Near the front of the intake manifold, you will see the EGR valve. Disconnect the electrical connector, remove the two 10 mm head bolts, remove the lead coated gasket from the intake. Be sure to clean the surface of all evidence of the gasket, using care to not get any into the intake. Place the new gasket on the EGR valve, using the bolts to keep it in place, put the new EGR on the intake. Tighten the bolts up evenly, plug the connector back in, and Rock and Roll.
It is right beside of the thermostat housing, right side of it. Just follow the top radistor hose to the engine and it will clamp to the thermostat housing.
How do i replace the purge valve on a 1999 Chevy Monte Carlo
Assuming V8 gasoline engine, it should be bolted onto the intake manifold.
either bad gasket under throttle body or bad iac valve
It is in the top of the valve cover. It has a black plastic line coming from the throttle body housing and going into one of the valve covers. It will be stuck in the end of the line and down into the valve cover.
I would be suprised if you have adjustable valves.
you first must replace the rotater valve you first must replace the rotater valve
The egr valve is on the top of the engine in the front it is plugged into your wiring harness and has two bolts holding it on, it is shaped like a cylinder and is next to the water jacket on the engine.
possibly a fuel regulator or bad valve
It doesn't have a serviceable PCV Valve. It is built into the valve cover.
== ==
The Internet.