0
I assume these are the heated seat switch bulbs you're referring to. I have a '98 and if you lift up the arm rest there are 2 screws you need to remove. The console trim should lift up at that point exposing the switches. Disconnect the wiring to the switch. you should then be able to remove the whole switch from the console. You'll then need to carefully pry the top of the switch btton of the switch assembly. The bulb is wired into a small white rubber boot which you can pull off. Pay attention to how its wired into the boot when you replace the bulb. Hope that helps.
What else can I help you with?
How do you replace the gear shift indicator light bulbs a 1997 Subaru Outback?
You have to remove the console cover. This starts with two screws in the console storage tray.
How do you replace the bulb in the seat heater switch console of a 2001 Subaru Outback Limited Wagon?
The light in the switch can not be changed, the whole switch would need to be replaced.
How do you replace the light that show the shifter position 2006 subaru outback?
Buy a new car
What is the cost to replace a backup light relay switch in a 1998 Subaru Outback with a manual transmission?
S100
Have Subaru Outback a back-up light relay?
Yes, it have none
How do you shut off flashers on my 1996 Subaru Outback?
To shut off the flashers on your 1996 Subaru Outback, locate the hazard light switch, which is usually found on the dashboard near the center console. Press the switch again to turn off the flashers. If they do not turn off, check the vehicle's manual for troubleshooting steps or ensure that the switch is not stuck.
How do you reset the oil change light Subaru Outback you?
A person can reset the oil change light on the Subaru Outback by turning off the vehicle and disconnecting the battery. Also, it is important to check the oil level just in case there is an issue.
Why do your light stay on on your 2005 Subaru Outback?
Brake lights? Check brake light switch for adjustment or replacement
How do you replace tail light assembly on 1996 Subaru Outback?
To replace the tail light assembly on a 1996 Subaru Outback, first, open the rear hatch and locate the screws or fasteners securing the tail light assembly. Remove these screws using a screwdriver, then gently pull the assembly away from the vehicle. Disconnect the electrical connector by pressing the tab and pulling it apart, then swap out the old assembly for the new one, reconnect the electrical plug, and secure it back in place with the screws. Finally, test the lights to ensure they are functioning properly.
How do you replace a driving-fog light bulb in a 2004 Subaru outback?
Access from under the front corner of the car. Remove or push small plastic cover out of the way. Unplug bulb and rotate to remove.
How do you replace the tail light bulb on a 1996 Subaru Outback?
See *Rear Combination Lights* on page 10-53 of your "Owner's Manual", under Section 10: Maintenance and Service - Replacing Bulbs.....
How do you replace a side marker bulbs on a 2002 subaru impreza outback sport?
To replace the side marker bulbs on a 2002 Subaru Impreza Outback Sport, first, locate the side marker light assembly on the front fender. Gently pull the assembly out by pressing the retaining tab and disconnect the electrical connector. Twist the bulb socket counterclockwise to remove it, then replace the old bulb with a new one. Reassemble by reversing the steps, ensuring everything is securely in place.
