They should be on the exhaust its self near a catalytic convertor. All you do is unplug and unscrew it from the exhaust ( THEY HAVE A WRENCH OR SOCKET FOR THIS ITS A N OXYGEN SENSOR SOCKET) and screw in the new tighten it and plug it in and your done that simple. Now, if it just has wires and no connector then you will have to cut the old connector off and plice in the new with wire connectors. ( NOT WIRE NUTS ). Hope this helps. Good Luck. If not and muffler shop can install them.
The cost of an oxygen sensor for a 2000 Mitsubishi Eclipse GT will cost between $55 and $80. The difference depends on location, dealer, and brand of sensor.
To replace the oxygen sensor on a Honda Odyssey, first unscrew the sensor. Then use a 22 mm socket or 7/8 inch wrench to replace the oxygen sensor.
Oxygen sensor: bank 1 sensor 2.
Depending on if you have a Cali Spec eclipse or a Fed. Spec eclipse, If you have a Federal Spec. you only have an oxygen sensor before the cat and right after the cat. and you won't have one in the header.
To replace the oxygen sensor disconnect the oxygen sensor electrical connector. Use an oxygen sensor socket to remove the sensor. spray the sensor with penetration oil if it is difficult to loosen. install in reverse.
An Oxygen sensor does not reset. You have to replace them and yes they are expensive.
You bring it to a service station and tell them to replace the oxygen sensor.
how do you replace oxygen sensor of 2001 bmw 318 ci es
Two, an upstream and a downstream oxygen sensor.
it is the upper stream o2 sensor before the convertor
You can not successfully clean an oxygen sensor. You need to replace it.
With an o2 sensor socket.