there are a few ways you can reach the two bolts holding it on. the head of the bolts are facing towards the rear of the truck and i believe they were 14 mm. you can access them from the underside, through the left wheel well(if you remove the tire) or you can remove the entire intake manifold and its right there in front of you. hope this helps
Need a diagram to set the timing Mitsubishi 1991 pu
To replace the starter on a 1994 Mitsubishi Mighty Max pickup truck, first disconnect the negative battery terminal to ensure safety. Then, locate the starter, which is usually found near the transmission bell housing. Remove the mounting bolts and electrical connections from the old starter, then install the new starter by reversing the process. Finally, reconnect the battery and test the new starter to ensure it’s functioning properly.
Socket wrench and 14mm sockets. Should take off all the bolts it worked for my 1990.
If your 1991 Mitsubishi Mighty Max dies after you start it up it could be one of several issues. There can be issue with the batter, fuel relay, or distributor.
The firing order for a 1991 Mitsubishi mighty max 3.0 v6 is 1, 2, 3, 4, 5, 6. The number 1 cylinder is on the front left.
max the mighty
Mounted on top and inside the fuel tank.
Max the Mighty is what Worm calls Max in the book, therefore it is Max
NO!!! It will be fine.
Gl-4 only
Max the Mighty was created in 1998.
"Max the Mighty" by Rodman Philbrick has 192 pages.