0
1. Locate the two screws on the underside of the steering column casing. Remove these two screws and set them aside.
2. Push the tilt wheel control all the way up and pop the two parts of the column casing apart with a long screwdriver.
3. Unplug the existing stalk and unscrew it.
4. Replace the stalk and reconnect it.
5. Slide the lower column casing and reattach it with the screws.
6. Slide the rubber tilt wheel cover back into place and snap the upper casing back in.
Hope this helps you out. :)
What else can I help you with?
How do you replace a starter in a 2001 Hyundai Santa Fe?
replace a starter in a 2001 hyundai santa fe
2010 Hyundai Sonata have a overdrive switch?
does the 2010 hyundai santa fe have an on off overdrive switch where is it located
How do you replace water pump 2002 Hyundai Santa Fe?
Remove and replace it.
Where is the oil pressure light switch located in a 2002 Hyundai Santa Fe?
The oil pressure light switch is located in the engine compartment on a 2002 Hyundai Santa Fe. It is to the right of the oil filter.
Replace pinion seal on 2003 Santa Fe?
how do you replace rack and pinion seals on a 2003 hyundai santa fe
How do you replace the fog light in the 2005 Hyundai Santa Fe?
=
How do you replace the brake light switch on a 2008 Hyundai Santa Fe?
To replace the brake light switch on a 2008 Hyundai Santa Fe, first, disconnect the vehicle's battery to ensure safety. Locate the brake light switch, which is typically mounted near the brake pedal arm. Remove the electrical connector and the retaining clip, then pull the old switch out and install the new one in the same position. Finally, reconnect the electrical connector, reattach any clips, and reconnect the battery to test the new switch.
How do you replace rear window brake light bulb on 2004 Hyundai Santa f e?
How do you replace rear window brake light bulb in the 2004 Hyundai Santa Fe?Read more: How_do_you_replace_rear_window_brake_light_bulb_on_2004_Hyundai_Santa_f_e
Where is the clutch safety switch on a 2002 Hyundai Santa Fe?
on the clutch pedal, just like a brake lamp switch
What should you do if you have trouble code P2125 for your 2003 Hyundai Santa Fe?
Trouble code P2125 means: Throttle/Pedal Position Sensor/Switch ""E"" Circuit I would replace the throttle position sensor
Where is the oil pressure switch located on a 2005 Hyundai Santa few 3.5L?
The oil pressure switch on a 2005 Hyundai Santa Fe with a 3.5L engine is typically located on the engine block, near the oil filter. It's usually positioned on the driver's side and can be accessed from beneath the vehicle. To replace it, you may need to remove the oil filter for better access. Always refer to the vehicle's service manual for precise location and instructions.
When was Hyundai Santa Fe created?
Hyundai Santa Fe was created in 2001.
