answersLogoWhite

0

Disconnect the battery for 10-30 seconds or use error code reader to do the same thing.

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

How do i reset ecm on 2001 Pontiac Grand Am?

unplug the 12v batt for at least 30's


How do you reset a Lincoln ls computer?

Unplug battery for 30 minutes then plug back on that will reset the ecm


Reset start engine light on 2001 Mitsubishi eclipse?

disconnect the positive connector on the battery


How do you reset the timing and ignition on a 2000 Mitsubishi eclipse v6 after replacing the battery to keep it from stalling?

I believe you need to drive it so the ECM relearns it's idle.


Where is the ecm located on a 2001 pathfinder?

ecm location 2001 pathfinder


How do I reset the ecm in a 1989 Chrysler new yorker 3.0l v6?

You can reset the ecm with a scan tool or by unhooking the battery.


How do you reset the computer on a 1999 dodge 2500 cummins?

To reset the ECM remove the battery cable (s) for a few minutes. Replace cable. ECM has been reset.


How to reset ecm in 1995-1997 chevy tahoe with 5.7?

Just unhook the battery cables for 5 mins, That will reset the ECM


How to Reset the computer on a 2002 Mercury Cougar?

ECM reset for 2002 merc couger


How do you replace a ECM on a Volvo V70 2001?

To replace the ECM (Engine Control Module) on a 2001 Volvo V70, start by disconnecting the negative battery terminal to prevent electrical shorts. Remove the ECM from its mounting location, which typically involves unscrewing it and disconnecting the wiring harness. Install the new ECM by connecting the wiring harness, securing it in place, and then reconnect the battery terminal. Finally, you may need to perform a reset or reprogram the new ECM to ensure it communicates properly with the vehicle systems.


How do you check ecm on a 2001 Toyota tundra?

To check the ECM on a 2001 Toyota Tundra, you will need the user manual.


How do you reset the codes on a 2006 peterbilt?

Disconnect the battery for five to 20 minutes. This will reset the ECM.