0
To reset the idle on a 1995 Mitsubishi 3000GT automatic, first ensure the engine is at operating temperature. Then, disconnect the battery for about 10-15 minutes to reset the ECU. Reconnect the battery, start the engine, and let it idle for about 10-15 minutes without any load to allow the ECU to relearn the idle parameters. Finally, check for any stored trouble codes that might indicate underlying issues affecting idle.
What else can I help you with?
Your 1995 3000gt mitsubshi stalls when you stop but starts right up when Idle drops it stalls?
the idle jet in the carb is blocked and needs to be cleaned out and reset
What is normal idle for 1995 Chevy TBI 350 automatic?
750 RPM
My 1995 3000gt idles at about 2000rpm's. what could be causing this?
A 2000 RPM idle in your 1995 3000GT could be caused by several issues, including a vacuum leak, a malfunctioning idle air control valve (IAC), or a dirty throttle body. Additionally, a sticking throttle cable or issues with the engine's sensors, such as the coolant temperature sensor, could also contribute to a high idle. It's advisable to check for any error codes and inspect these components to diagnose the problem accurately.
Does a 95 dodge ram 1500 have to be started to check the transmission fluid?
The fluid level in an automatic transmission in a 1995 Dodge Truck should be checked at idle in Neutral with the engine at operating temperature.The fluid level in an automatic transmission in a 1995 Dodge Truck should be checked at idle in Neutral with the engine at operating temperature.
What is the idle RPM for a 95 Chevy cavalier 22 liter with automatic transmission?
The idle on my 1995 Chevy Cavalier stays at 600rpm's when i check it with the scanner. Hope this helps BE SAFE dirt420ba
Your 1994 3000gt stalls when you are stoped if you give it gas it is ok?
idle control valve
Why would a 92 Mitsubishi 3000GT SL non-turbo stall when idling after the battery was changed?
The computer in your vehicle controls idle (base and curb). When the battery was disconnected the computer lost memory of the set idle. The car needs to re-learn the idle specs, sometimes can be done by driving for around 15-20 minutes. If not you will need to see a mitsu dealer and have a multi scanner hooked up to reset the idle.
What causes 1995 3000GT to stall when you put it in gear?
A 1995 Mitsubishi 3000GT may stall when put in gear due to several potential issues. Common causes include a faulty idle air control valve, which affects engine idle stability, or a malfunctioning mass airflow sensor that disrupts the air-fuel mixture. Additionally, issues with the transmission, such as low fluid levels or a failing torque converter, can also contribute to stalling. It's important to conduct a thorough diagnostic to pinpoint the exact cause.
What is the idle RPM for a 1.9L 1995 mecrury tracer with automatic transmission?
Idle RPM is set automatically by the computer. if you have slow or rough idle try fuel injector cleaner, then new air filter, new plugs or plug wires (try them in that order)
What is the ignition timing for a 1995 3000gt?
The ignition timing for a 1995 Mitsubishi 3000GT typically ranges from 5 to 10 degrees before top dead center (BTDC) at idle, depending on the engine version and specific conditions. It's important to consult the vehicle's service manual for the exact specifications and to ensure proper adjustments based on the fuel used and engine condition. Always verify with a timing light for accurate settings.
1995 mitubishi won't idle--what is the problem?
have lost my idle on a 1995 mitsubishi--what is the problem
How do you test a crank angle sensor on a 1991 3000gt sl 3.0L?
1991 to 1993 3000gt do not have a crank sensor. Only a cam sensor. And when does go out the car will not start or have a very irregular idle.
