answersLogoWhite

0

how down the reset button approximately 15 to 20 seconds...then you would notice the maintenance lights flashes. at that time, just press the reset button once more. that's all to it.

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

How do you Reset Maintenance Warning Light on a 2008 Toyota 4Runner?

How to Reset Maintenance Warning Light on a 2008 Toyota 4Runner


How can you reset maintenance light on 2008 sequoia?

Check your owners manual


Reset 2008 Honda Civic after tire change?

how to reset a tire sensor for a 2008 Honda civic si


How do you reset the B1 code on a 2008 Honda Odyssey?

Honda's maintenance minder says to, "refer to Civic Sedan's owner's manual."


How do i Turn off maintenance minder on a 2008 civic?

I'm not certain how it's done on a Civic, but most cars can be reset by pulling the battery cable (hot/red) and letting it sit for an hour or so. This has worked for me in the past.


How do you reset oil light in 2008 Honda accord?

With the ignition off, push and hold the odometer reset button, now turn the ignition on without starting the engine. After 5 seconds the maintenance required light will go out and reset.


How do you turn off the maintenance light on a 2008 Camry?

Disconect battery for 5 minutes. Disconnect the battery for 5 minutes. Should reset engine light.


How do you reset the maintenance light on a 2008 Mercedes Benz clk 350?

Not in the manuel, manuel-is closely guarded by MB for selfish reasons.....


How do you reset change oil maintenance light on a 2008 Dodge Caliber?

Turn on Ignition - depress gas pedal 3 times


How do you reset 2008 Honda Element service light?

How do you reset 2008 honda element service light?


How do you reset service light for 2008 Honda civic?

turn key on hold reset button down located on the left hand side of the dash , it will start blinking lift your finger and press two more times and it is reset.


How do you reset a oil light on a 2008 Nissan Altima?

To reset "Maintenance Notice" on the display, turn the ignition key to ON, with engine off. Select the "Maintenance Schedule' key by using the button to right or left. Using the button select the "Reset" key and push the "Enter" button.