Check your owners manual
How to Reset Maintenance Warning Light on a 2008 Toyota 4Runner
To reset the maintenance light on a 2008 Saturn Vue, start by turning the ignition to the "ON" position without starting the engine. Press the gas pedal three times within five seconds, then turn the ignition off. When you turn the ignition back on, the maintenance light should be reset. If it doesn't turn off, repeat the steps to ensure the reset was successful.
To reset the maintenance light on a 2008 Toyota Tacoma, first turn the ignition to the "ON" position without starting the engine. Press the gas pedal three times within five seconds, then turn the ignition off. When you turn the ignition back on, the maintenance light should be reset. If it doesn't turn off, repeat the process.
how down the reset button approximately 15 to 20 seconds...then you would notice the maintenance lights flashes. at that time, just press the reset button once more. that's all to it.
With the ignition off, push and hold the odometer reset button, now turn the ignition on without starting the engine. After 5 seconds the maintenance required light will go out and reset.
To reset the maintenance required message on a 2008 Acura TSX, start by turning the ignition to the "ON" position without starting the engine. Then, press the gas pedal three times quickly. This should reset the maintenance light. Finally, turn off the ignition and start the vehicle to ensure the message is cleared.
Disconect battery for 5 minutes. Disconnect the battery for 5 minutes. Should reset engine light.
Not in the manuel, manuel-is closely guarded by MB for selfish reasons.....
Turn on Ignition - depress gas pedal 3 times
How do you reset 2008 honda element service light?
To reset "Maintenance Notice" on the display, turn the ignition key to ON, with engine off. Select the "Maintenance Schedule' key by using the button to right or left. Using the button select the "Reset" key and push the "Enter" button.
how do you reset check engine light in 2008 buick lucerne