0
What else can I help you with?
How do you reset maintenance light on 2008 Toyota tacoma?
To reset the maintenance light on a 2008 Toyota Tacoma, first turn the ignition to the "ON" position without starting the engine. Press the gas pedal three times within five seconds, then turn the ignition off. When you turn the ignition back on, the maintenance light should be reset. If it doesn't turn off, repeat the process.
How do you Reset Maintenance Warning Light on a 2008 Toyota 4Runner?
How to Reset Maintenance Warning Light on a 2008 Toyota 4Runner
How can you reset maintenance light on 2008 sequoia?
Check your owners manual
How do you reset the check engine light on 2008 Tacoma after the 5000 mile oil change?
Reset as follows: with the ignition switch in the off position, hold in the hold in the trip odometer. Now turn your key to the on position and you will see a series of zeros or dashes begin to appear. Once that stops, your maintenance light will be reset.
How do you turn Maintenance Required light off on a 2008 Toyota Tacoma?
This light comes on about every 5000 miles or so to remind you to change the oil. Reset as follows: with the ignition switch in the off position, hold in the hold in the trip odometer. Now turn your key to the on position and you will see a series of zeros or dashes begin to appear. Once that stops, your maintenance light will be reset.
How do you reset maintenance light on 2008 Saturn Vue?
To reset the maintenance light on a 2008 Saturn Vue, start by turning the ignition to the "ON" position without starting the engine. Press the gas pedal three times within five seconds, then turn the ignition off. When you turn the ignition back on, the maintenance light should be reset. If it doesn't turn off, repeat the steps to ensure the reset was successful.
How do you reset the maintenance light on a 2008 civic?
how down the reset button approximately 15 to 20 seconds...then you would notice the maintenance lights flashes. at that time, just press the reset button once more. that's all to it.
How do you reset oil light in 2008 Honda accord?
With the ignition off, push and hold the odometer reset button, now turn the ignition on without starting the engine. After 5 seconds the maintenance required light will go out and reset.
How do you reset the maintenance required message for 2008 Acura TSX?
To reset the maintenance required message on a 2008 Acura TSX, start by turning the ignition to the "ON" position without starting the engine. Then, press the gas pedal three times quickly. This should reset the maintenance light. Finally, turn off the ignition and start the vehicle to ensure the message is cleared.
How do you turn off the maintenance light on a 2008 Camry?
Disconect battery for 5 minutes. Disconnect the battery for 5 minutes. Should reset engine light.
How do you reset change oil maintenance light on a 2008 Dodge Caliber?
Turn on Ignition - depress gas pedal 3 times
How do you reset the maintenance light on a 2008 Mercedes Benz clk 350?
Not in the manuel, manuel-is closely guarded by MB for selfish reasons.....
