the best way to reset your service light is with a ob11 scanner but you can disconnect the negative battery cable and also pull the hazard fuse under the hood in your fuse panel for a couple of minutes however if there is something wrong with the engine the light will come back on maybe in an hour or a day . If you use the scanner it will tell you why it came on in the first place hope this helps
The easiest way to reset the check engine light on a 1995 Acura Integra is to unhook the battery for a few minutes. If the light is still on after hooking it up again, there is probably still a problem that needs to be fixed with the engine.
You can take it to a professional, or you can check the reading yourself. A check engine light can mean many things.
To check a engine light you need some kind of scan tool and it will show you what kind of code or codes is set for the engine light to go off.
The brake light fuse on a 1995 Acura Integra is located inside the cabin of the vehicle. It is on the same circuit as the dash and hazard lights.
On the passenger side of the center console behind the head unit for the stereo.
most likely because you have no oil in your engine check it i change the oil i went to mechanic he check the oil but light showing .
it is under the transmission. u can see part of the wire when you are looking into the engine bay. the wire should be close to the radiator.
i am pretty sure there are no daytime running lamps on a 90' integra...
The brake lights are located in the trunk of a 1997 Acura Integra. To replace them open the trunk and find the plastic housing. Remove and replace the bulbs.
The 1991 Acura Integra brake lamp number is 2057. See sources and related links below for a picture and more information.
It sounds like your VSS(Vehicle Speed Sensor) has gone bad, which will turn on your check engine light.
check the bulbs