Insert the ignition key, and turn it to the ACC (accessory) position. Turn off the radio. Press the display button until Oil Life shows on the radio display. Press the seek button until Tire Pressure Monitor displays. Press the 2nd preset/#2 button. Press the display button again. The tire pressure monitor should now be reset.
To reset the tire pressure light on a 2003 Chevrolet Monte Carlo, first ensure that all tires are properly inflated to the recommended pressure. Next, turn the ignition to the "On" position without starting the engine. Press the gas pedal three times within five seconds, then turn the ignition off. Start the engine again, and the tire pressure light should be reset. If the light remains on, check for any underlying tire pressure issues or consult a mechanic.
In a 2000 to reset the low tire pressure light, first make sure the tires are properly inflated and then to reset the light pull the head light switch from off to parking lights and back to off 3 times. Otherwise it will say it your owners manual.
Check and adjust air pressure to specs in all the tires and it will set itself after a few miles of driving.
The light is on because there is a problem with the system. The light will remain on until the problem is fixed. Once the problem is fixed the light will reset itself after a short drive.
unhook a battery cable for about 3 minutes and re-hook.
No.
Take it to a mechanic, and have them erase the codes. Auto zone and advance will not do it as they are not mechanics
AFTER you inflate the tires to the correct pressure, turn the ignition to the on position. Then pull the headlight knob from the OFF position to the parking light position three times. This should reset the system. This is the easiest way but you can also reset it through the radio. If you would rather do it this way, it is on 6-44 in your owner's manual
Unhook the car battery.
you eat 25 corndogs ! :]
General Motors cars do not have a reset switch.
how do I set reset ignition security on a 1999 z34 monte carlo