Sometimes a code reader can re-set. I had the problem of the computer not re-setting and consulted the factory mechanics manual. It required 4 miles of constant driving at 50 mph, then 11 minutes varying between 40 and 50 mph. Then stop, turn off ignition, turn on ignition and repeat. It worked for me - and I was able to pass smog.
How do you reset the Airbag warning light on a 1995 Toyota Avalon?
How do I Reset dashboard warning lights on 90 Lexus ES250
To reset the warning lights on a 2005 Jeep Grand Cherokee, start by turning the ignition key to the "On" position without starting the engine. Then, press the gas pedal three times within ten seconds. After that, turn the ignition off and then restart the engine; the warning lights should be reset. If the lights remain on, it may indicate an underlying issue that needs to be addressed.
If the warning lights go off in a Chevy Tahoe, it indicates a problem. In order to reset these lights the problem must be solved.
Depends on what warning light you are asking about.
on most vehicles you can reset warning lights by simply unconnected a battery cable
The check engine and other dash warning lights can be reset by disconnecting the vehicles battery for more then 5 minutes. If warning light continues after reconnecting battery then there is still a problem.
To reset warning lights on your dashboard, first, address the underlying issue that triggered the light. Once resolved, turn off the vehicle and disconnect the battery for about 15 minutes, then reconnect it. Alternatively, you can use an OBD-II scanner to clear the codes associated with the warning lights. Finally, start the vehicle to check if the warning lights remain off.
When warning lights go off on a car, it means that there is a problem to fix. To reset the lights, one must fix the problem, or they can use a scanner to reset it.
I want reset computer avalon 2007 limited
Most cars are equipped to reset oil change warning lights. If the Fiat Doblo does not have instructions in its manual, then you will have to have the dealer or a mechanic do it for you.
fix the problem causing them and than have to take it to shop so they can reset it with their scanning tool,