0
What else can I help you with?
Where is the fuel pump on a 88 Mazda B2200?
Left hand side of the block towards the back, just follow the hoses off the carb.
What newer engine can I swap into my 1987 Mazda B2200 pick up?
I have a 88 B2200 and i did a 318 V8 swap. Wasnt hard. Added coils to front. Welded in the mounts and changed nothing else. Fast but managable.
Where is locate PCV valve Mazda 88 b2200?
I believe that it is right on top of the valve cover, a (little short 90 degree hose) goes directly to the air cleaner. It comes out forward of the air cleaner.
How do you know you have the cam pulley back on correctly on Mazda 88 b2200?
To ensure the cam pulley is correctly installed on a Mazda 88 B2200, align the pulley’s timing mark with the corresponding mark on the cylinder head or timing cover at top dead center (TDC) of the compression stroke for cylinder one. Additionally, verify that the timing belt is properly tensioned and that the belt teeth fit snugly in the pulley grooves. Finally, rotate the engine manually to confirm that there are no obstructions and that everything operates smoothly without any binding.
What car can you get a turbo off of to put on an 86 Mazda b2000 2.0?
The exhaust manifold and turbo from the 88-92 Mazda 626, MX-6, and Ford Probe turbo models will bolt onto the 86-93 B2000 and B2200. See the attached link for additional information.
88 Mazda b2200 does waterpum and timing belt go hand in hand?
yes i would recommend changing both.make sure you pay attention to what belt you have as their is a round tooth and square tooth belt so you get the right one!if you need any help check out www.mazdabscene.com lots of good people on there and all Mazda truck owners!i am a member on there (lofosho86)good luck!!
What do the following codes p0140 and p0141 indicate on an Oldsmobile 88 1997?
Not knowing what the following codes are will not allow someone to know which indicate an Oldsmobile 88. Information should be provided as to what the codes are.
Where is the blower motor resistor on 1988 Mazda B2200?
On the 88, remove the glove box by removing all the screws you see when you open the glove box door. You will see a 4 wire connector off to the right. It is plugged into the resistor. This is a common failure when any of the lower speeds of the blower motor fan don't work (high speed is not affected by the resistor).
Is a headlight turnsignal arm from a 88 tracer interchangeable with an 88 323 Mazda dealer wants over 200.00?
It should work as the Tracer is just a rebadged Mazda 323. A close look at them should let you know, especially if the wiring is the same.
What are combo card codes for card 88 in The 39 Clues?
P29rp379xp
How do you bleed master cylinder for 88 b2200?
To bleed the master cylinder on a 1988 Mazda B2200, first, remove the master cylinder reservoir cap and ensure it's filled with brake fluid. Then, use a brake bleeder tool or a helper to pump the brake pedal several times and hold it down. While the pedal is held, open the bleeder valve on the cylinder to allow air and fluid to escape, then close the valve before releasing the pedal. Repeat this process until no more air bubbles are visible in the fluid, ensuring the reservoir remains filled throughout.
1987 to 1989 Mazda rx7 are the same afm?
No. 86-88 are the same. 89-91 are the same.
