answersLogoWhite

0

With the the crank pulley at tdc, the white mark on the cam gear lines up with the center of the rocker shaft.

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

How do you time turbo on 2001 Isuzu npr need repair?

i have 2001 isuzu npr motor 4he1 i need wow the turbo no work


2004 Isuzu NPR oil capacities- Diesel?

For the 4he1-tc diesel motor the service manual lists the crankcase capacity with filter at 13liters (3.4 gallon). I have validated this on my 2002....rick


What engine is more powerful between Isuzu 4hj1 and Isuzu 4he1?

Oh, dude, let me break it down for you. The Isuzu 4HE1 engine is more powerful than the 4HJ1. It's like comparing a sloth to a cheetah in terms of speed... well, maybe not that extreme, but you get the idea. So, if you're looking for a bit more oomph, go with the 4HE1.


What is the valve clearance for Isuzu 4he1 engine?

0.016" cold both intake and exhaust. valves closed


What is the Oil capacity in a NKR 200 Isuzu truck?

What engine ?? 4he1 10lt 4hf1t / 4hf1t 13.5lt


How to make overhaul isuzu 4hf1 engine?

FIT FOR ISUZU NPR NKR 4HF1 OVERHAUL REBUILD KIT 4.3L. New Overhaul Piston Liner Kit (4 Cylinder) for 99-04 ISUZU NPR 4.8L 4HE1-TC. 4HF1 overhaul rebuild kit for Isuzu engine NKR NPR 4.3L WPN400 NKR66 Truck parts


What is the proper ratio of differential of Isuzu elf 4he1 engine?

It depends on your road conditions. If I were to use on plain highway I would recommend high speed diff, but if you belong to highlands low speed diffs are advisable...


What is cause of piston failure in cummins diesel engine?

It depends on the year. If it is the older 12 valve usually the pump timing is adavanced way too far or the fuel plate in the govenor housing has been modified. Too much fuel not enough air. If it is the common rail i have had several trucks that have just had faulty injectors that will dribble fuel creating extremely high egts. The vp44 pump equipped cummins i have not seen a lot of problems out of because the injectors were full mechanical and the pump was marginal at best. They were not capable in stick trim of overfueling. Cummins did change the piston design in the last few years and started beveling the edge of the combustion bowl because the lip that used to protrude could crack over time. This is also true of the 7.3 powerstroke and Isuzu 4he1 engines. Remember if you are adding extra fuel keep an eye on your exhaust gas temps and back sure your fuel system and turbo are up to the task.