Chainsaw?
you take it apart and fix it
how do you take out a transmission on a 1990 Honda accord
No it will be a 5 digit #'s only. If you don't have the code your the original selling dealer may or you have to get the serial # off the back of the radio (you have to take it out) and take that to a Honda dealer and they can give it to you.
You're radio is not working because the circuit board may be the problem. If you have less than 105 k miles on you're Honda accord then I would suggest that you take it in to get the circuit board replaced on you're radio.
There is something wrong with the airbag deployment system. Take the car to the Dealer.
Take a look at the lift sensor mounted on the left front fender.
Depending on the year! The stock radio on my 1990 accord required a 4 digit code in order to program. Just obtain the serial number on the bottom of the radio and take it to your nearest Honda dealer and they'll give you the code that's required! A much easier way is to go to the link I will post and sign up at Honda Owner Link. With the VIN number you can get the code for free if it is the OEM radio and you do not have to remove the radio to get the serial number.
They are adjusted with shims. As you do not have a shim kit for this purpose and it would be expensive for you to buy one, take your Accord to a Honda dealer or mechanic who has a shim kit and have them adjust to valve lash. This is really not a DIY repair due to how it is done.
The Honda Accord engine of this year is an interference engine. Install this belt incorrectly, start the engine, and it will suffer damage. For this reason, I suggest you take it to a professional or buy a repair manual so you can do it right.
have take motor and trans out 1996 Honda accord put timing belt
in order to get the radio code you must first take out the stereo and get the serial number off the back of the radio then call a Honda dealership with the VIN and proof of ownership and they can get you the code. You then enter the code using the preset buttons. GOOD LUCK!!
* Remove the ashtray and ashtray holder * Remove the mounting screws lower the radio unplug the electrical connector and antenna lead then pull the radio out of dashboard