You can't turn it off. HAVE THIS CHECKED IMMEDIATELY! It is signalling a malfunction of the airbag system. Without knowing the probelm you don't know if the bags simply won't work OR if they're going to explode in your face at any moment without warning!
You can turn it off. There are videos online to show you how. If there is a real problem then it will go back on and stay on. Then you can look into having someone look at it.
Check the airbag ring wiring behind the airbag. does it turn on when you turn the wheel?
The airbag light stays on when the computer detects a malfunction. The problem will need to be repaired before the light will turn off.
The airbag light stays on when the computer has detected a malfunction and set a code. The failure will need to be repaired before the light can be reset.
How do you turn on the passenger airbag on a 05 Honda accord lx
The airbag light stays on when there is a malfunction. The failure needs repaired before the light will go out. You need to have the system checked for codes with a scan tool.
To turn on the airbag system in a 2011 Chevy Aveo, ensure that the ignition is in the "On" position. The airbag system should automatically activate when the vehicle is started, indicated by the airbag warning light on the dashboard, which will briefly illuminate and then turn off. If the light stays on, there may be an issue with the airbag system that needs to be diagnosed by a professional. Always refer to the owner’s manual for specific instructions and safety precautions.
To reset the airbag light on a 1994 Honda Civic locate the wiring for the SRS unit underneath the dashboard. There will be a yellow clip that connects to a fuse box. Unplug it and jump the sensor using two small wires. Turn the car on and off twice to reset the light.
To reset the airbag light on a 2005 Honda Accord, first ensure the vehicle is turned off. Then, turn the ignition to the "On" position without starting the engine. Next, locate the airbag diagnostic connector, usually found under the dashboard, and use a paperclip to bridge the two terminals for about six seconds. Finally, remove the paperclip, turn off the ignition, and then restart the vehicle to see if the airbag light has gone off. If it remains on, there may be a deeper issue that requires professional diagnosis.
To reset your airbag light, in a Nissan Altima, you should turn the car on. From there, as soon as the airbag light stops flashing, turn the car off instantly. Repeat this three times to reset the airbag light.
If the airbag light is on, there is a defect somewhere in that circuit. You turn the light off by isolating and fixing the defect. Start with the fuse box.
To reset the airbag light on a 2003 Honda Civic, first, ensure that the vehicle's ignition is turned off. Next, locate the OBD-II port under the dashboard and connect an OBD-II scanner that can read airbag codes. After retrieving any stored error codes, clear them using the scanner. Finally, turn the ignition back on to see if the airbag light has reset; if the light remains on, there may be a persistent issue that requires further diagnosis.
The SRS light stays on when the airbag computer detects a malfunction and sets a code. The light can not be turned off until the malfunction is repaired.