put the key in the ignition. with the key in the OFF position, push and hold the trip odometer button in. hold the button down while turning the key to the ACC position. Continue to hold the button in for about ten seconds until the light turns off.
To reset the "Service Due Soon" light on a 2006 Acura TL, start by turning the ignition to the "On" position without starting the engine. Press the gas pedal three times within five seconds. Then, turn the ignition off and back on; the light should be reset. If it doesn’t turn off, repeat the process.
Hold trip reset button down then turn key on but do not crank engine over light maint. light will go off after a couple of second.
To reset the service light on an Acura RDX, first turn the ignition to the "On" position without starting the engine. Then, press the gas pedal three times and turn the ignition off. Start the engine to ensure the service light has been reset. If it remains on, you may need to repeat the process or check for other underlying issues.
You need to twist the turn signal switch.
To turn off the service engine light on a 2008 Acura MDX, you can start by checking for any diagnostic trouble codes (DTCs) using an OBD-II scanner. If the issue has been resolved, the light may turn off after a few driving cycles. Alternatively, you can disconnect the battery for about 15 minutes to reset the system, but this will reset all settings in the car. If the light remains on after addressing any issues, it may indicate a persistent problem that needs further inspection.
how do you turn of the service light on a 04 seat arosa
Push the select and reset switch at the same time, turn the ignition switch ON (II), and hold them more then 10 seconds. The above sentence came straight from the 2001 Acura TL service manual
The light is on because you have disabled the Vehicle Stability Assist (VSA). Push the VSA button to turn the system back on and the light will go out.
Service your car.
"How do you turn off the service engine light on a 2002 cadillac escalade?" When replacing oxygen sensors, will the service engine turn off?
Just turn off the air back service light..
To turn off the maintenance light on an Acura MDX, start by turning on the ignition without starting the engine. Press the gas pedal three times within five seconds. After that, turn the ignition off and then back on to verify that the maintenance light has been reset. If it remains on, repeat the process.