To turn off the maintenance light in a Honda Pilot, start by turning the ignition to the "ON" position without starting the engine. Press the gas pedal three times within five seconds. Then, turn the ignition off. When you restart the vehicle, the maintenance light should be reset.
Change the oil.
The maintenance required light only goes on after 7,500 miles since last 'maintenance'. The maintence required light will not turn off by replacing or changing anything, the only way to turn it off is by putting your key in the key slot next to the light.
To turn on the pilot light on a gas appliance, locate the pilot light button or knob and turn it to the "pilot" position. Then, press and hold the button while using a long lighter to ignite the pilot light. Keep holding the button for about 30 seconds to allow the pilot light to stay lit. If the pilot light goes out, repeat the process.
There is no such thing as a '93 Pilot. In 2003 The Honda Pilot replaced the earlier Honda Passport.
To turn on a pilot light, locate the gas valve and pilot light knob on the appliance. Turn the gas valve to the "pilot" position and press down on the pilot light knob while using a lighter or match to ignite the pilot flame. Hold the knob down for a few seconds to allow the pilot light to stay lit, then release the knob.
To turn on the pilot light for your water heater, locate the pilot light assembly near the bottom of the water heater. Turn the gas control knob to the "pilot" setting and hold it down. While holding the knob down, use a long lighter to ignite the pilot light. Once the pilot light is lit, continue holding the knob down for about 30 seconds before releasing it. If the pilot light stays lit, turn the gas control knob to the "on" position to start the water heater.
To turn on the water heater pilot, locate the pilot light button or knob on the water heater. Turn the knob to the "pilot" setting and hold it down. While holding the knob down, use a long lighter to ignite the pilot light. Once the pilot light is lit, continue holding the knob down for about a minute before releasing it. This should successfully turn on the water heater pilot.
Very common problem on the 2003 Honda Pilot. The tumblers go bad and it will cost around $400 for a dealer to replace. Honda should have a recall on this.
To turn the pilot light on, locate the pilot light button or knob on your appliance. Hold the button down and simultaneously press the ignition button to spark the flame. Keep holding the pilot light button for a few seconds to allow the flame to ignite and stay on.
To turn on the water heater pilot light, locate the pilot light assembly near the bottom of the water heater. Turn the gas control knob to the "pilot" setting and press it down. While holding the knob down, use a long lighter to ignite the pilot light. Keep holding the knob down for about 30 seconds, then release it. If the pilot light stays lit, turn the gas control knob to the "on" position. If it doesn't stay lit, repeat the process.
To turn on the pilot light on your water heater, locate the pilot light assembly near the bottom of the water heater. Turn the gas control knob to the "pilot" setting and hold it down. While holding the knob down, use a long lighter to ignite the pilot light. Keep holding the knob down for about 30 seconds, then release it. If the pilot light stays lit, turn the gas control knob to the "on" position. If it doesn't stay lit, repeat the process.
It should turn off automatically after you put in the correct tire pressure. I just did this the other day.