0
To turn off the service required light in a 2010 Toyota Prius, you can follow these steps: First, turn the ignition to the "ON" position without starting the engine. Then, press the gas pedal three times within five seconds. Finally, turn the ignition off and then back on to check if the light has turned off. If it remains on, the vehicle may require professional service.
What else can I help you with?
What are some of the features that come standard on a Toyota Prius?
There are numerous features that come standard on a Toyota Prius. Some of the features that come standard on a Toyota Prius are light-emitting diode headlights, the smart key system, and anti-lock disc brakes.
How do you reset check engine light for Toyota Prius?
To reset the engine light on a Toyota Prius, disconnect the negative battery cable and let off for about five minutes, then reconnect it. The light should go off after the first couple start ups.
Fix the Automatic headlight leveling system warning light on a 05 Toyota Prius?
On my 05 Prius the problem was the axle height sensor located near the left rear wheel.
How does the smart car saves energy?
It has a small motor, and is very light to save fuel. The Toyota prius is more econmical
How do you reset the service required light on a 2008 Toyota Auris?
Prees odo meter button down and turn on ignition wait 10 seconds
What is warning light with a car with a spanner through it mean?
w hat does warning light on dashboard shaped like acar with line through it mean 2008 toyota prius
How do you reset 2006 Toyota Prius maintenance light?
To reset the maintenance light on a 2006 Toyota Prius, first, turn the ignition to the "ON" position without starting the engine. Press the gas pedal three times within five seconds, then turn the ignition off. When you turn the ignition back on, the maintenance light should be reset. If it remains on, repeat the steps to ensure the process was completed correctly.
What does it mean when the 2003 jeep liberty service required light comes on?
Service required is the oil change reminder. Service engine soon would be the check engine light.
How do you remove a tail light assembly on a 2008 Toyota Prius?
To remove the tail light assembly on a 2008 Toyota Prius, first, open the trunk and locate the access panel on the side of the tail light you wish to remove. Remove the screws or clips securing the access panel and set it aside. Then, unscrew the bolts holding the tail light assembly in place, gently pull the assembly out, and disconnect the electrical connector. Finally, replace the assembly by reversing the steps.
How do you switch high intensity module on 04 Toyota Prius from a damaged light to a new headlight when the module is not included?
You would have to buy a computer control module from
How do you reset service light on Toyota auris?
To reset service light on Toyota Auris one can activate the code error reader which is a diagnostic tool. You can also hold down the odometer reset button.
What does it mean when maintenance required light blinks 8 times and then goes out when i start my 2010 Toyota Camry?
When the maintenance required light in your 2010 Toyota Camry blinks eight times and then goes out, it typically indicates that the vehicle's maintenance reminder system has been activated. This usually signifies that it's time for routine maintenance, such as an oil change or other scheduled service, based on the mileage or time interval since the last service. It’s advisable to check your owner’s manual for specific maintenance recommendations and to reset the light after completing the required maintenance.
