Hi, normally there are 2 types of electrical connectors. One with one clip in the middle and the other with two clips on both sides if I 'm not mistaken !
To remove a connector, you need to press on that clip (or clips) then shake it from side to side while pulling out at the same time. Use other hand to hold the other half of connector (NOT the wire) .Sometimes you need a little force !
Good luck !
LOOSE OR CORRODED ELECTRICAL CONNECTION?
fgcffcf
accord 91
* Remove the ashtray and ashtray holder * Remove the mounting screws lower the radio unplug the electrical connector and antenna lead then pull the radio out of dashboard
on the 1996 Accord it is behind the ash tray
Unplug the door switch.
* Remove the ashtray and ashtray holder * Remove the mounting screws lower the radio unplug the electrical connector and antenna lead then pull the radio out of dashboard
Loose bulb or loose connection.
The 1997 Honda Accord OBD 2 port is inside storage behind ashtray
To install a stereo in a 1985 Honda Accord, make wire to wire connections using either a solder iron and electrical tape.
* Remove the ashtray and ashtray holder * Remove the radio and mounting plate screws and lower the radio and unplug the electrical connector and antenna lead then push the radio out of the dashboard
list all fuses and manual resets for the electrical system on a Honda accord lx 2.2 l engine