120
watts = volts X ampsSo240V X 10A = 2400W - not 2500.
No, you cannot use a 125V 2A fuse to replace a 125V 10A fuse. The lower-rated 2A fuse will blow under normal operating conditions if the current exceeds 2 amps, while the 10A fuse is designed to handle higher current levels without blowing. Using a fuse with a lower amperage rating than required can lead to frequent outages and potential damage to the circuit or devices. Always replace a fuse with one that matches the original's specifications.
Yes, you can substitute a 6A 250V component with a 10A 250V component as long as the voltage rating is the same and the application does not exceed the 10A current rating. The higher-rated component can handle more current, making it a suitable replacement. However, ensure that other specifications, such as physical size and connection compatibility, are also met. Always consult relevant guidelines to ensure safety and compliance.
No, it is not safe to replace a 250V 10A fuse with a 125V 15A fuse. The voltage rating of the fuse must be equal to or greater than the system voltage, and the amperage rating must be equal to or lower than the rated current of the circuit. Using a lower voltage or higher amperage fuse can lead to safety hazards, including potential fire risks.
Rr t/lps its a 10a fuse
It depends on how many amps it was designed for. A 12.5kV/600v 10kVA 3 phase transformer can handle ~.5 amps on the primary and ~10A on the secondary. A 600/120V 10kVA 3 phase transformer can handle ~10A on the primary and ~50 on the secondary.
Engine bay fuse box (10A Radio Clock)
On my 1993 (Right and Drive) Accord Coupe the fuse is located under a panel next to the bonnet (hood) release handle which is in the driver's footwell. On my car it's a 10A fuse but check the diagram in the inside of the flap
Under the hood #4 10a
Fuse 7: 10A Red; Buzzer Module, Stop Lamps Fuse
the fuse is located under the wood.it is a red 10A fuse marked etcs
Its fuse number 3 located under the bonnet next to the battery. A 10A fuse.