0
What else can I help you with?
What is the cost to replace an intake valve on 1998 Jeep Cherokee?
Labor: $103 - $131 Parts: $20 - $52
How do you replace the valve cover gasket on a 1990 Honda Accord?
How much does it cost parts and labor to replace a valve cover gasket on a 1990 Honda Accord 4door.
Cost to replace Valve seal cover?
Its called a valve cover gasket kit and the job should cost about 300.00 Parts and labor.
How do you replace the intake control valve in a Kia Sorento 2003?
To replace the intake control valve in a 2003 Kia Sorento, first disconnect the negative battery terminal for safety. Remove any necessary components obstructing access to the valve, such as the intake manifold or air intake duct. Unplug the electrical connector from the valve, then remove the mounting bolts and take out the old valve. Install the new valve, secure it with bolts, reconnect the electrical connector, and reassemble any parts you removed. Finally, reconnect the battery and start the engine to ensure proper operation.
What does it cost to replace a Variable Valve Timing solenoid on a 2002 Camry?
I had two changed on my 2000 Avalon, and I paid about $350, parts and labor.
What is a reasonable amount of time and cost to replace an intake manifold gasket and an EGR valve on a 1999 Mercury Mountaineer 6-cylinder OHC?
It should take 1.5 hours to do the intake, assuming a rate of $99 an hour for labor plus parts it should be around $200. It should take one half hour for the EGR valve but the part is expensive so around $300 total for that.
Where is the EGR valve on a 2002 2.3L Ford Ranger Does the intake manifold have to be removed to replace it?
no its out side of the intake
How can you tell the difference between intake valve and exhuast valve on a 1987 Chevy 305 want to replace valve stem seals but intake and exhaust are different seals which one is which?
intake valves are the larger valves or if you count from from either end its number 2,3,6,&7 valve
How much does it cost to replace bad valve on crown vic?
A Lot, it requires the motor to be taken apart, so labor costs are really high. your looking at around $800 atleast for labor plus the parts.
How do you replace the valve lifters on a cavalier?
To replace the valve lifters on a Cavalier, remove the intake manifold, valve covers and rocker arms. Remove the heads of the lifters using needle-nose pliers.
How do you replace the intake gasket on a 1992 Chevy Lumina Z34?
I'll assume Lower Intake Gasket, since they tend to cause vacuum leaks. Get a manual from Autozone and expect about 4 hrs labor, you need to take off the upper intake manifold just to replace the Lower Intake Gasket. Probably should change/clean the PCV valve while ur in there. Good luck, man.
How much does it cost to replace valve seals on a 2008 dodge avenger?
The cost to replace valve seals on a 2008 Dodge Avenger typically ranges from $800 to $1,500, depending on labor rates and whether additional repairs are needed. This estimate includes parts and labor, with the majority of the cost attributed to labor since accessing the valve seals requires significant engine disassembly. It's advisable to get quotes from multiple repair shops for a more accurate estimate.
