Up to 24
12 galons
Remove the bolts that hold the distributor cap onto the distributor. Once this is off the rotor can be reached and replaced on a 1994 Acura Integra.
13.2 gallons or 50 liters.
An Acura Integra GSR engine holds 4.2 liters of oil. Other variants of the engine ,such as the LS, holds less with a capacity of 4.0 liters of oil.
To replace the lower control arms on a 1994 Acura Integra safely raise and stabilize the car. Remove the lower ball joints and two bolts that hold the lower control arms to the car. Pull them off. Replace with a new unit.
Around 10 or 12, depends on what transmission is in it. Acura Legend auto trans holds 12 an it's a 2.7 v6, it is impossible to take that much
It was built to hold 34 ounces of R12. It will need retrofitted to R134a. After that the capacity will be about 90 percent of the old charge.
no more than four buddy and that's if ur BONE DRY..don't try it...trust
The clutch cylinder on a 1994 Acura Integra is bled by placing a tubing on the slave cylinder bleeder valve and placing the other end underneath brake fluid. Pump the clutch pedal several times and hold it down. Release the bleeder valve. Keep doing this process until bubbles no longer exit.
Deal Specifications are listed as: Without New Filter - 3.7 qts With New Filter - 4.0 qts After Overhaul - 4.9 qts
Remove the air intake tubing from the throttle body. Find the lower radiator hose, and follow it to where it connects to the engine which will be just above the starter. The thermostat is behind the elbow that the hose is connected to - unbolt the 2 or 3 bolts that hold the elbow to the engine and it should come right out.
The shocks are a common replaceable part. They can be found or ordered at most any local auto parts or online dealer.