0
What else can I help you with?
How much should front struts cost to replace on a 1997 infiniti qx4?
The parts cost about $200, and if you find an honest mechanic about $200 to install them. There is no alighnment nessasary for replacing the struts on Qx4s
How do you replace the clutch in a 1997 Nissan Pathfinder?
get a mecanic to do the job
Where can you find a schematic and instructions to replace the inner and outer front bearings on a 1997 Nissan Pathfinder 3.3l 4x4?
in a haynes auto repair manual
Does a 97 Toyota tacoma 4x4 have front shocks or struts?
My 1997 3.4L 4x4 tacoma has struts but some may have springs My 1997 3.4L 4x4 tacoma has struts but some may have springs
Does a 1997 ford aerostar have shocks or struts?
There are ( shock absorbers ) on a 1997 Ford Aerostar ( front and rear )
How do you fix a lean problem on a 1997 Ford Contour?
Replace the shocks and struts! :-D
How do you replace struts in 1997 Toyota 4Runner?
The 4Runner doesn't have struts; it has coil-over shocks in front. After removing the old shocks a spring compressor is required to remove the springs and install them on the new shocks. Take it to a front end shop that has the proper compressor and tools; it's very dangerous if you don't have good equipment and experience. The rear shocks are easy to replace by yourself.
Does a 1997 jetta have struts or shocks?
a 1997 Jetta gt has struts.
What struts come on a 1997 Chevrolet Blazer S-10 ZR2?
That vehicle doesn't use struts. It uses regular shock absorbers on the front and rear.
Can you use struts from a 1997 town and country lxi on a 1999 town and country lx?
Same part number for front struts with or without springs (loaded).
How do you replace strut on 1997 Chevrolet s-10?
S10 dont have struts the have coil springs and shocks
What cause 1997 Toyota Camry front end struts make loose noise?
There are at least two reasons. First one is malfunctioning strut itself (leakage). Second one is holders which attache struts to the car body have some rubber parts inside. As time goes the rubber parts wear off and fail. In the first case you have to replace the fail strut(s). For the second one you have replace the holders. Sometimes it happens you that you have to replace struts as well as holders.
