Open the tailgate. There are two bolts on the right side, of your left tail light. Should be a 10mm socket or a Philips screwdriver can also be used to remove them. The light is clipped in still to the body. You have to push the light to the left while keeping the light square to the body and it will pop out. Its important to push the light to the left not pull. Of course reverse for the passenger / right side.
you don't replace the tail light you just replace the bulb in it
On a 2012 toyota Highlander, How do you replace tail light Assembly
Remove tail light housing. Remove lamp. Replace lamp. Replace tail light housing.
You can not, you will have to replace the entire tail light.
you can take the tail light out by unscrewing the wing nuts in the trunk, when all wing nuts are off pull the tail light out then take the light bulbs out to replace the tail light.
How do you replace a broken tail light cover for a 2005 Nissan Pathfinder ?
Have you checked the fuses or bulbs?
Have a look at this link: http://www.wikihow.com/Replace-a-Tail-Light-on-a-Dodge-Grand-Caravan
the tail light is screwed in from the inside of the bed of the truck
I went to the dealer, and I have been quoted $90.00 to replace the climate control nob light bulb. How do I get to the dash board to replace it?
Open the trunk. Loosen the black thumb latch wing nuts that hold the tail light assembly in place. pull the tail light assembly out. You should be able to acces the tail light bulbs to replace them.
To replace the tail light lens on a 2008 Acura, first, open the trunk and locate the access panel behind the tail light assembly. Remove the screws or clips securing the panel, then disconnect the electrical connector for the tail light. Carefully unscrew and remove the tail light assembly, replace the lens, and reassemble by reversing the steps. Finally, test the tail light to ensure it functions properly before closing the trunk.