0
Add your answer:
Earn +20 pts
Why is the gauge and running lights not working on 1992 acura integra?
Dimmer switch
How do you change the bulbs for the instrument panellights for an Acura Integra?
Changing the instrument panel lights require removal of the dashboard. With the dashboard removed pull the gauge cluster out and take off the bulbs. Install the new bulbs.
Your speedometer on your Acura Integra stop working is their a fuse?
Answermy 99 acura integra has a fuse for gauge cluster, alternator, speed sensor vss o2 sensor is fuse 15 under the dashboard that fuse control all of them check that out
Acura integra 1993 temperature gauge high?
Check the fan. Sometimes the wires come unplugged. Mine does it sometimes too.
How do you replace a speedometer cable on a 1990 acura integra?
Start by removing the gauge cluster, unhook the speedometer cable from back of cluster. Pull speedo cable thru the firewall, follow it down to the transmission, and then unhook it. Install in reverse order of removal.
How do you recharge the air conditioner for a 1991 Acura Integra?
Connect freon gauges and a freon container to the low side ac port of the 1991 Integra. With the engine running and the ac on high, open the freon valve to fill the system until the gauge reads full.
What is the role of the boost gauge in an internal combustion engine?
A boost gauge in an internal combustion engine has the role of a pressure gauge. The gauge indicates the manifold's air pressure or a turbocharger or supercharger's boost pressure.
How do you install boost gauge on Toyota supra?
if it is a manual gauge it is as easy as following the directions. hook up a wire for the light, a ground and the vacuum hose spliced somewhere into a current vacuum line with the T that is most likely provided.
How to remove gauge cluster on a 1992 acura integra. I have removed center console and driver and pass. panels to get to additional screws. but won't pop off around ac panel. are there more screws?
why does my speedometer needle bounce, when I'm doin less than 80
How do you install a after market boost gauge on a 1991 mr2 Toyota turbo?
you have to tap into your intake manifold and install the pressure line there. you can only put it on the intake manifold. then run your line through the firewall. make sure there is no way that it can become cut or kinked. then mount your gauge and hook up the line and the power can come from any 12 volt source.
Where can one purchase a boost meter or gauge?
One can purchase a boost meter or gauge from Jegs and Glow Shift Direct. These meters can also be bought at Treadstone Performance, Egauges and Sunmit Racing.
Why doesn't my boost gauge go all the way in my 01 gtp?
either because your not running enough boost or your a moron
