answersLogoWhite

0

To remove the CV joints on a 2002 Axiom 4x4, start by safely lifting the vehicle and removing the front wheels. Next, detach the axle nut and any necessary components, such as the brake caliper and rotor, to access the CV axle. Use a pry bar to pop the CV joint out of the transmission or differential and then pull the axle free from the hub. Ensure to replace any retaining clips or seals during reinstallation for optimal performance.

User Avatar

AnswerBot

2mo ago

What else can I help you with?

Related Questions

How do you change ball joints on a 1991 ford f-150 4x4?

This is a general procedure checklist for removing most balljoints on 4x4's. - Remove wheel - remove brakes/caliper/rotor - remove wheel bearing/hub assy/4x4 assy (some assy's don't need removing to replace ball joints, if able to get to joint) - need press to remove joints or a hammer, chisel and lot's of elbow grease. Usually torches make it easier. Or remove the spindle and take to a bench press to remove the ball joints. Most places I know do this. - installation is the reverse Ball joints on 4x4's are typically a job that cost's lot's and for good reason. The joints can be a real treat getting out. Good luck.


How do you remove a front axle on a Honda 420 rancher 4x4?

How do you get the axle out to change the boots on the cv joints


Is it required to break the transmission loose from the engine to drop the oil pan on a 4.7L 2002 Dodge Ram 1500 engine?

Either remove the trans, or remove the front axle on a 4x4.Either remove the trans, or remove the front axle on a 4x4.


How do you replace front ball joints on 91 Nissan 4x4 King Cab?

on the upper ball joints just remove the four bolts on the upper control arm and use a picker fork to remove the balljoint from the steering knuckle. for the lower ball joints you have to remove the axle then repeat the same steps for the uppers


How do you change ball joints on f350 4x4?

To change ball joints on a Ford F350 4x4, first, safely lift the vehicle and remove the front wheels. Then, disconnect the brake caliper and rotor, followed by the tie rod end and control arm bolts to access the ball joints. Use a ball joint press to remove the old ball joints and install the new ones. Finally, reassemble all components in reverse order, ensuring everything is tightened to the manufacturer's specifications.


What size wrench is needed to remove the calipers on a 2002 gmc 1500 hd 4x4 sierra?

15 mm


Where is the 4X4 fuse located at in 2002 Ford Explorer?

where is the 4x4 fuse located in a 2002 ford explorer.


How do you remove the ball joints on your 2001 dodge ram 2500 4x4 i cant seem to get my press set up correctly?

pound them out with a hammer and then press the bottom 1 in first


How 2 change ball joints in a 84 Ford F-250 4x4?

The ball joints can be replaced by removing the wheel. Remove the rotor and brakes. Pound the old ball joint out. Insert the new ball joint with a ball joint compressor.


How do you replace the ball joints on a 1995 ford F150 4x4?

Replacing Ball joints Check Related Links Below


How do you replace lower ball joints on 1990 f150 4x4?

First remove the steering knuckle completely from the truck. Then remove any circlips (snap rings.) Then, use a ball joint press to push the old ball joints out and new ones in. Replace any circlips. Assemble the rest. Get the wheel alignment adjusted.


How do you remove 4x4 switch 2007 gmc envoy?

how do you remove 4x4 switch on a 2007 gmc envoy