To replace the hood strut on a 2005 Lexus ES330, first, prop the hood open securely. Use a flathead screwdriver to carefully pry off the retaining clips or ball sockets from the old strut on both ends. Install the new strut by aligning it with the ball sockets and pushing it onto the balls until it clicks into place. Repeat for the other side if needed, and ensure the hood operates smoothly before removing the prop.
Pioneer is the manufacture.
The 2005 Lexus ES330 uses the 3MZ-FE Toyota V6 engine, which has a timing belt.
The EFI fuse on a 2005 Lexus ES330 is located in the engine compartment fuse box. To access it, open the hood and find the fuse box, which is typically near the battery. The EFI fuse is usually labeled, so you can identify it by checking the diagram on the lid of the fuse box. Make sure to replace it with a fuse of the same amperage if needed.
one is under the hood but that's obvious - the other is behind the ash/coin tray - just pull out the door
On a 2005 Lexus ES330, the fuel filter is integrated into the fuel pump assembly, which is located inside the fuel tank. To access it, you'll typically need to remove the rear seat cushion and the access panel to reach the fuel pump. The filter itself is not a separate component that can be easily replaced, so if it's clogged or needs replacement, the entire fuel pump assembly usually needs to be replaced.
In a 2005 Lexus ES330, the fuse for the cruise control is located in the engine compartment fuse box. To access it, open the hood and locate the fuse box near the battery. Check the diagram on the cover of the fuse box to identify the specific fuse related to the cruise control system. If the cruise control is not functioning, inspecting this fuse for any damage or a blown condition is a good first step.
To remove the rear seat cushion of a 2005 Lexus ES330, first, locate the release tabs at the front of the cushion. Pull up on the front of the seat cushion while pressing the release tabs to detach it from the brackets. Once released, lift the cushion upwards and out of the vehicle. Ensure to check for any seatbelt clips or wiring that may need to be disconnected before fully removing the cushion.
To remove the back seat of a 2005 Lexus ES330, start by locating and removing the bolts securing the seat bottom, usually found at the front or under the seat. Once the seat bottom is detached, lift it upwards to remove it. Next, to remove the seat back, locate the bolts or clips at the base and sides, then carefully unfasten them before lifting the seat back out of the vehicle. Always consult the owner’s manual for specific instructions and safety precautions.
The 2005 Lexus ES330 takes 24" drivers and 20" passenger side wiper blades. See sources and related links below for more information. Since there are over 22 different wiper arm attachments, do not buy wipers just by length only. Be sure to lookup exact wiper blade part numbers by vehicle make, model and year for the brand wiper you decide to purchase. This ensures correct length AND correct attachment.
To replace the struts on a 2005 Kia Amanti, start by safely lifting the vehicle and removing the front wheels. Next, detach the brake line and any associated components connected to the strut assembly. Remove the strut mounting bolts from the top and bottom of the strut, then carefully remove the old strut. Install the new strut by reversing the disassembly process, ensuring that all bolts are securely tightened before reattaching the wheels and lowering the vehicle.
dose a 2005 kia amanti strut need pressed in place
dose a 2005 Kia amanti strut need pressed in place