0
tow it to your mechanic.......FIRST..is the coolant mixing with the oil? (light brown milky looking oil) if water is in oil, how far was it driven like that? there is the possibility that the engine bearings were damaged if water is in oil and it was run very long like that...i have purchased cars that need head gasket replaced, fixed them only to have the engine start knocking in a day or 2......this is a big job that requires more than a little mechanical experience....this job requires removing the valve cover, intake and exhaust manifolds, it is an overhead cam engine so you will have to reset the timing, i usually mark timing so i can put timing back without having to find top-dead center on #1 cylinder (big pain to reset timing if your not careful) you will need to have the head checked for cracks and warpage (at your local automotive machine shop) and if its not cracked they will resurface to ensure its not warped. if its cracked it will most likely have to be replaced, some shops can repair certain cracks but it might be cheaper to replace..when you put head back on you will need the head bolt re-torque specs and bolt tightening sequence...a chilton manual will give specific removal instructions and head bolt re-tightening specs if you dare...
What else can I help you with?
Warranty on 2007 suzuki forenza?
for how long is the transmission on a Suzuki Forenza 2008
Is 2005 suzuki forenza interference engine?
does the 2005 Suzuki forenza have an interference motor or not
How do you replace the camshaft position sensor on 2004 suzuki forenza?
One would replace the camshaft position sensor on a 2004 Suzuki Forenza by taking it to a certified auto mechanic. The mechanic would then check out and repair the issue, thereby rendering the car back to a serviceable condition.
Pics of where to add transmission fluid on 2008 suzuki forenza?
can I add trasmision fluid on suzuki forenza 2008
What is Head bolt torque 2.0 suzuki forenza?
What is head bolt torque for 2004 Suzuki forenza 2.0
How do you replace brake light switch on suzuki forenza?
To replace the brake light switch on a Suzuki Forenza, locate it on the pedal shaft, release the wires that connect it, twist and then take out the old brake light switch and put a new switch in its place. The job can be done by any handy owner.
How do you remove a 2005 Suzuki Forenza headlamp after disconnecting wire harness?
You remove a few bolts to remove the entire headlight assembly. There is a video on YouTube on exactly this. Do a search for Forenza Replace.
What is the most recent Suzuki Forenza model?
Suzuki produced the Forenza for only five years. The Forenza was introduced in 2004. The last year of production was 2008, therefore the most recent model would be a 2008 Forenza.
How do you replace a head gasket for 1986 suzuki samuari?
should you drain oil in the car if the head gasket is blow
How do you change the valve cover gasket on 2004 suzuki forenza?
To change the valve cover gasket on a 2004 Suzuki Forenza, first, disconnect the battery and remove any components obstructing access to the valve cover, such as the air intake or ignition coils. Unbolt the valve cover and gently lift it off, taking care not to damage any surrounding components. Remove the old gasket, clean the surfaces thoroughly, then place the new gasket in position. Reassemble by reversing the disassembly steps, ensuring all bolts are torqued to the manufacturer's specifications.
What is the bolt pattern for a suzuki forenza?
4x4.5" or 4x114.3
Where is the starter on 2006 Suzuki forenza?
under the hood
