0
What else can I help you with?
At 65 mph what is the normal rpm reading for a 2003 VW Jetta with a 2.0 liter engine and automatic transmission?
3000
What automatic transmission fluid do you use for 1988 wrangler?
normal atf
Automatic transmission warning light camaro 95?
shifts normal with normal driving conditions when driving hard transmission stalls.have to ease off gas to go to next gear
How do you check fluid in automatic transmission of mini cooper 2004?
To check the automatic transmission fluid in a 2004 Mini Cooper, first ensure the vehicle is on level ground and the engine is running at normal operating temperature. Locate the transmission dipstick, which is usually found near the back of the engine compartment. Pull out the dipstick, wipe it clean, reinsert it, and then check the fluid level against the markings. If the fluid is low, add the appropriate type of transmission fluid through the dipstick tube, but avoid overfilling.
Why would your car just suddenly die on its own you will be driving like normal then when you come to a stop or even while driving it will just die please help?
If you have a manual transmission, then simply the car's engine dies because you release the clutch too quicly. If your car is automatic than you might have engine or transmission problems.
How do you drive a dodge dart with dual dry cluch auto transmission?
You put it in drive and press the gas. It drives just like a normal automatic transmission.
Why does your engine rev when it shifts gears?
in an automatic transmission when it shifts the belts that hold the planetary gears that control the gear ratios grab the next gear before it releases the previous gear. while the transmission is in two gears at once the engine doesn't provide the power to the transmission so with the lack of tension on the motor it allows it to build up speed before it slows back down when the transmission releases the lower gear What about a manual transmission? Is it normal for it to still do this same thing?
Why will an Achieva automatic transmission stop changing gears if the fluid level is normal?
There are many reasons. Take it to a trans shop.
Why wont the car go forward when its in gear instead of just the engine revving high?
Chances are, particularly if this is an automatic transmission, you are low on tranny fluid. To check this, the engine needs to be at normal operating temperature and idling. Checking tranny fluid when the engine is cold and not idling will give a false reading, indicating that it is full ...
Where is the transmission fluid dipstick located on a 2003 Cadillac CTS?
There is no transmission dipstick. Check fluid level by removing the inspection plug on the left side of the transmission. Only check fluid level with engine running otherwise fluid will overflow through the hole since fluid accumulates in pan with engine off. Normal level is to the top of the port. Also, if you have the automatic transmission on your 2003 CTS, there is no way to check the fluid level. See your owner's manual.
Why does a 1989 Cherokee shift up at high RPM when in normal drive and shift down as soon as accelerator is released?
The behavior you're observing in the 1989 Jeep Cherokee is likely due to the automatic transmission's shifting logic, which is designed to optimize performance and fuel efficiency. When the engine reaches high RPMs, the transmission may shift up to prevent engine strain and reduce fuel consumption. Conversely, releasing the accelerator reduces throttle pressure, prompting the transmission to downshift in response to lower power demand. This automatic behavior helps maintain optimal engine performance and drivability.
How do you check the automatic transmission level on a Isuzu VehiCROSS 3.5 V6?
To check the automatic transmission fluid level on an Isuzu VehiCROSS 3.5 V6, first ensure the vehicle is on level ground and the engine is running at normal operating temperature. Locate the transmission dipstick, usually found near the back of the engine, and remove it. Wipe it clean, reinsert it fully, then remove it again to check the fluid level against the marked indicators; the level should be within the "Full" and "Add" marks. If necessary, add the appropriate type of transmission fluid through the dipstick tube using a funnel.
