well in most cases the engine cover is a safety so as the average owner doesnt go to check the oil and burn them selves, plus if you throw a belt you wont dent the hood (dunno why i said that) but id elave it on if you can it woudl probably void the waranty
Yes it will fit the Hyundai Sante Fe.
spark plug cover:)
Pop the hood. Remove the plastic engine cover. Filter is located on top of engine on the right side. It has a round black plastic cover. Turn to open it (CounterClockwise). Pull the entire plastic cover and filter assembly out (Keep it vertical- do not tip it or oil will spill out onto your engine). Replace gaskets and filter. Screw back in. I find it amazingly easy, you don't have to climb under car or jack it up. ALL cars should do it this way.
It is under the timing belt cover near the crankshaft pully / harmonic balancer.
The PCV valve on a 2009 Hyundai Santa Fe with a 2.7L engine is located on the valve cover. You'll find it on the driver's side, near the rear of the engine. It is typically connected by a hose to the intake manifold. You may need to remove the engine cover for easier access.
Under the cover where the spark plug wires go into on top of the engine.
On the top of the engine. (take off the plastic engine cover) It is in a black plastic housing that screws off. You have to buy the paper filter and 2 o rings from the Hyundai dealer.
The part number 29110-3Y000 refers to the front cover assembly for certain Hyundai vehicles, specifically related to the engine or timing system. This component is typically part of the engine's external assembly and plays a role in protecting internal engine parts. It's important to consult your vehicle's manual or a Hyundai dealer for specific compatibility and application details for your model.
they are located under the cover strip down the center of the engine. strokerace
A crankshaft sensor, on a Hyundai XG350, can be installed by simply plugging the new sensor into the slot of the old sensor. The sensor can be located on the back of the engine cover.
Under the dust cover. Remove the 4 bolts that are covering it.
it follows the radiator pump on the right side of the engine you can see it better if you take off the cover.