answersLogoWhite

0

What else can I help you with?

Related Questions

What is the Location of medium voltage switch gear?

A medium voltage switch gear is on the low voltage side of the transformer. This medium voltage switch is very cost efficient as well.


Measure the voltage across a voltmeter and a switch?

If the switch is closed (connected) the voltage across it will read 0V. If the switch is open (disconnected) the voltage across it could be anything, it just depends on what the voltage between the wires going into the switch is.


How does turtwig evolve?

put him in first then switch him out so he doesnt get hurt put him in first then switch him out so he doesnt get hurt put him in first then switch him out so he doesnt get hurt


Have 2000 Nissan frontier blower for ac heat only works on highest setting what should you check for thanks?

There is a thing called the resistor box that drops the voltage through the switch leaving the full voltage to run on number 4 of the switch. Locate this resistor and replace, this should fix problem.hope this helps


How do you locate a kill switch for a 1986 Nissan pickup?

no such switch.


When measuring voltage drop across a switch what is the maximum allowable voltage drop?

The voltage drop should be as close to zero as would be readable by a typical volt meter. If it is measurable you likely have a problem with corrosion or oxidation in switch that is increasing resistance. If you can measure a voltage drop across a closed switch contact, replace the switch. Or the switch is open, try flipping the switch!


What is the definition of a dimmer switch?

A switch that regulates voltage to something.


What quantity does the voltmeter measure when the switch is open?

When the switch is open, the voltmeter measures the potential difference or voltage across the two points connected by the switch, as no current flows through the circuit. This measured voltage is often referred to as the open-circuit voltage.


In a circuit if the switch is closed how many volts go across the switch?

For an ideal switch, there will be no voltage drop across it. In reality, there will be a very small voltage drop, and this will be dependent on how well made the switch is, and what it is made out of.


Where is the dimmer switch locate on a 1977 Cadillac devilla?

Look for switch on floor


How do you turn your magnet on?

Locate the switch and turn it on.


Where do you locate a trigger switch for a EL1?

its on the distributor