0
What else can I help you with?
Check indicator of your Daewoo matiz turns on suddenly The car starts vibrating when it is ON what could be the problem?
Well, there are a bunch of problems. If the car vibrates that means that you should check the oil. Than, if the check indicator is on, I've heard from the mecanics that the board computer has a problem. So, you have to go to the service immediately. If heard and read a lot of problems with this Check indicator. Good luck!
What is the problem when indicator is always on third?
If an indicator is always on the third position, it may indicate a connection issue within the device or a malfunction in the hardware or software. It could also suggest an error in the setup or calibration of the indicator. It is advisable to check the user manual or contact customer support for troubleshooting steps.
Why is the malfunction indicator lamp on Honda Pilot lit up?
This light could be on due to a defective fuel cap.
Why does indicator stick on instead of flashing?
An indicator light that stays on instead of flashing typically indicates a malfunction or a fault in the system. This could be due to a burned-out bulb, a short circuit, or an issue with the indicator relay. Additionally, it may signify that the turn signal mechanism is not functioning properly, requiring inspection or replacement. Always consult a professional if you're unsure or if the problem persists.
What is code p0320 and how to find problem?
The p0320m is a crankshaft position malfunction. The sensor could be bad, it could be a wiring issue, or a distributor problem.
Why is your left indicator stuck on even when engine switched off and hazards come on but dont flash on frontera?
If the left indicator on your Frontera remains stuck even when the engine is off, it could be due to a faulty indicator stalk or relay that is causing a malfunction. The hazards not flashing may indicate a blown fuse or a problem with the hazard switch itself. It's advisable to check the electrical connections and fuses related to the indicator and hazard systems for any issues. If the problem persists, consulting a professional mechanic may be necessary for a thorough diagnosis.
Honda 2003 Malfunction Indicator Lamp?
go to the dealer thy can tel you for sure why it is on could be oxygn sensor failur very comon on civics if that is the model
What causes an engine surge in a Daewoo Matiz?
Mass Air Flow MAF sensor could be your, problem check that!
Indicator malfunction on Fiat Panda 1.1?
If the indicator on a Fiat Panda 1.1 is malfunctioning, it could be due to a blown fuse, a faulty relay, or a problem with the indicator switch itself. Checking the fuse box for any blown fuses related to the indicator system is a good first step. If the fuses are intact, the issue might lie in the relay or the wiring, which may require further inspection or replacement. It's advisable to consult the vehicle's manual or a professional mechanic for a thorough diagnosis.
What is PO443?
PO443 is an indication of a problem with an indicator lamp illumination. There are no drivability issues with this code, but safety could be an problem at night.
When the malfunction indicator light come on in your 1995 Nissan 200SX What does it mean?
When the malfunction indicator light (MIL) comes on in a 1995 Nissan 200SX, it typically signifies that the vehicle's onboard diagnostic system has detected an issue with the engine or emissions system. This could be due to various problems, such as a faulty sensor, a loose gas cap, or more serious engine issues. It's important to have the vehicle scanned for trouble codes to identify the specific problem and address it promptly to avoid further damage.
What does a steady yellow indicator means?
It could mean there's a problem with the electrical mechanics of the car.
