answersLogoWhite

0

Well, there are a bunch of problems. If the car vibrates that means that you should check the oil. Than, if the check indicator is on, I've heard from the mecanics that the board computer has a problem. So, you have to go to the service immediately. If heard and read a lot of problems with this Check indicator. Good luck!

User Avatar

Wiki User

18y ago

What else can I help you with?

Related Questions

Why does your Daewoo matiz suddenly lose power?

hi i had this problem while ago was down to rotor arm and cap


How do you check what the fault is on a daewoo matiz malfuction indicator lamp comes on?

Go to someone who has a diagnostic meter , they will be able to tell you what is causing the problem, it is usually a sensor.


Which way does a distributor turn on a Daewoo Lanos 1999 model 1.5L?

I have 1999 lanos and it is a distributor-less model.


Daewoo nubira veers to one side when accelerating?

I have a 2000 Daewoo Nubira and I had the control arm replaced and it fixed the problem.


My 1996 daewoo cielo wont start engine malfuntion indicator is on?

check to see if the engine fuse is blown in the fuse panel i have had this problem with a mazda ute it might be what is wrong with cielo then check to see if you are getting fuel to your fuel rail and check spark at the coil


Where is the light for heater in Daewoo lanos how to replace?

In the Daewoo Lanos, the heater light typically refers to the indicator for the heater, which is part of the climate control panel. To replace it, you will need to remove the dashboard panel and the climate control unit. Once the unit is accessible, locate the bulb for the heater indicator, remove it, and replace it with a new one. After replacement, reassemble the dashboard to complete the process.


How do you improve the break of Daewoo lanos?

need a bit more info is the breaks a problem or do you just want them improved or what the problem is


What is wrong when my Daewoo will not accelerate and will then take off?

If your Daewoo is not accelerating properly and then suddenly takes off, it could indicate several issues. Common problems include a malfunctioning throttle position sensor, a clogged fuel filter, or issues with the transmission. Additionally, there could be an issue with the engine's air intake or fuel delivery system. It's advisable to have a mechanic diagnose the problem to ensure safe and efficient operation.


How do you reset the check engine light on a Daewoo nubira?

Have vehicle scanned to determine the problem


Does daewoo nexia 1.5 have a lamp indicator for fuel?

Yes, there is a lamp for the fuel. It is on the same line, where all other lamps are lokated, in the right end of the line.


Malfunction indicator lamp stays on 52 reg daewoo matiz - what could be the problem?

There are more than 50 problems that will cause a check engine light to stay on. The most common reason is the circuit board needs to be replaced. The only way to know why the light is on is to run a diagnostic test.


Deawoo Malfunction Indicator Lamp?

The Daewoo Malfunction Indicator Lamp comes on for a bulb check when you turn the ignition switch to the 'on' position. The light should then go out when you start the car. If the light stays on, it means a problem was detected. One possible problem is that either the connectors or the harness shorted out, or that the circuit is open. It is also possible that the bulb needs to be replaced. In many cases, the cause is either an exceptionally high or low amount of voltage being sent to the ECM through the MIL at a time when the bulb should not be lit up.