A small bit of oil, if on the firing end or at the initial threads is acceptable, but may indicate wear along the rings or head gasket. Oil in the area above the crush washer and threads (where the plug wire is connected) could indicate that the plug was not in tightly enough, or that your valve cover gasket needs to be replaced.
The spark plug gap for a 1996 Mazda Familia should be set between 1.0 and 1.1 mm. This is stated in the adjustment data from Mazda.
Stock gap recommended is 0.040", for Turbocharged or Supercharged Miatas 0.034" is recommended.
The gap setting is .38 to .42
what is spark plug for mazda tribute 2004
To change the spark plugs on a 2006 Mazda Miata, first, ensure the engine is cool and disconnect the negative battery terminal. Remove the ignition coil by unbolting it and disconnecting the electrical connector, then take out the old spark plug using a spark plug socket and ratchet. Install the new spark plugs, making sure to torque them to the manufacturer’s specifications, and reassemble the ignition coils. Finally, reconnect the battery terminal and start the engine to check for proper operation.
4 Spark Plugs are lined in a row at the top of the engine down the middle (Follow the wires on the top!). A basic, NGK BKR6E Spark Plug pack is generally recommended.
What's the spark plug gap for 2003 Mazda 2300 pic up ?
.044
The spark plug gap on a 2002 Mazda 626 should be set at .044 inches. A new spark plug will come preset from the factory.
It is important to remember the spark plug gap when changing the spark plugs of a vehicle. A 1998 Mazda B2500 has a spark plug gap of 0.042 to 0.046 inches.
Where are the spark plugs on a 2004 mazda rx8?
The spark plug gap on a 1994 Mazda 1.8L MFI DOHC is .044 (thousandths of an inch)