1342
1342 is the firing order of the cylinders, the question was order of the plug wires between the plugs and the distributor, which I have found from another source, the sequence from the distributor starting at the top is: top plug goes to #1 cylinder (far left), second plug goes to #4 cylider (far right), third plug goes to #2 cylinder and fourth plug goes to #3 cylinder. Hope this helps some people since I couldn't find it anywhere online. I also believe this is the same for all Daewoo models in this age range with 4 cylinder motors as this sequence came off a Nubira but worked for my Lanos.
the firing order is 1342 on a daeoo lanos 1998
1 - 3 - 4 - 2
The firing order on a 2001 Daewoo Lanos Sport is 1, 3, 4, 2. The number one cylinder is on the left side when viewed from the front of the vehicle.
firing order is 1-3-4-2
1342
go to daewoous.com and order service manual.
To install a water pump on a Daewoo Lanos, first, ensure the engine is cool and disconnect the battery. Remove any components obstructing access to the water pump, such as the serpentine belt and timing cover, if necessary. Unbolt the old water pump, clean the mounting surface, then apply a gasket or sealant as needed before positioning the new pump. Finally, reassemble all components in reverse order, refill the coolant, and check for leaks.
The firing order for the 1.6L Daewoo Lanos is 1-3-4-2. This means that the ignition sequence starts with cylinder 1, followed by cylinder 3, then 4, and finally 2. It's essential to ensure that the coil pack is connected correctly according to this order for optimal engine performance. Always refer to the vehicle's service manual for detailed specifications and diagrams.
The firing order for the Daewoo Lanos with a 1.4-liter engine is 1-3-4-2. This means that the cylinders fire in that specific sequence to ensure proper engine operation and balance. Always refer to the vehicle's manual for specific maintenance and repair guidance.
You can order cut replacement keys through the Daewoo Motor America website at www.daewoous.com. You must include the complete Vehicle Identification Number (VIN) in order to determine the correct key code.
To change the front wheel bearing on a Daewoo Lanos SCX, start by safely lifting the vehicle and removing the front wheel. Next, detach the brake caliper and rotor to access the hub assembly, then remove the hub by unbolting it from the steering knuckle. Replace the old bearing with a new one, ensuring it is properly seated, and reassemble the components in reverse order. Finally, torque all bolts to the manufacturer’s specifications and reinstall the wheel before lowering the vehicle.
1423 for all daewoo 2.0 and 2.2