0
What else can I help you with?
Subaru Legacy 1996 Computer reset?
Unbolt the battery for at least ten seconds. Mechanic, Why are the parking lights flashing after new battery installation?
How to reset driving distance to empty of 2102 Subaru legacy?
To reset the driving distance to empty on a 2012 Subaru Legacy, first ensure the vehicle is in the "On" or "Run" position without starting the engine. Then, press and hold the trip meter reset button on the dashboard until the display resets. This action typically recalibrates the fuel gauge, including the distance to empty reading. If needed, you can also try refueling the vehicle to help the system update.
What is the 95 subaru legacy trouble code po115?
Engine Coolant Temperature Sensor Circuit -replace the temp sender under the passenger side of the throttle body and reset the mil light.
Is there a reset button on 2003 Subaru Outback?
where is black reset button umder drivers dash
How do you reset the computer for the 98 Subaru Outback Legacy?
Remove one battery terminal and touch it to the other to discharge capacitors in the system. Reconnect the terminal and you are good to go. Don't forget to clean the terminal while you have it off.
How do you Reset Auto Door Locks on a 1998 Subaru Outback?
How do you reset the auto locks on a 1998 Subaru. Disconnected the battery to clean terminals. Now the auto lock does not work from the door switches
How do you reset check engine light in 1998 Subaru legacy outback 2.5?
You need an OBDII computer a) to read the reason for the check engine light, and b) to reset the error code if you know what caused the light to come on. If you don't fix the condition that caused the light in the first place, it will probably occur again.
Why do the parking lights on your 1998 Subaru Legacy blink when the cars is turned off?
Your system may just need to be reset. That recently happened to me and the Subaru service dept was able to fix it quickly and easily. I think it happens when your vehicle suffers a power failure. My battery had died, and upon replacement, the lights flashed. Also my power locks ceased to function. That also needed a quick reset and everything was soon back to normal. Good luck. Desk
How do you reset the oil change light Subaru Outback you?
A person can reset the oil change light on the Subaru Outback by turning off the vehicle and disconnecting the battery. Also, it is important to check the oil level just in case there is an issue.
How do you reset the check engine light on a 2000 Subaru Forester?
With the proper scan tool.
How do you quickly reset the check engine light on a 1990 2L Subaru Legacy GT Wagon?
Disconnecting the Battery (and Reconnecting it of course) will get the light to go out. Assuming you have fixed the problem, it should not come back on. I do not know if this will "reset" it, though. It may still give you the code for the problem you just fixed instead of a new code if a different problem comes up, but I doubt it.
How do you reset computer in a 1997 Subaru wrx?
Disconnect the battery, push the brake pedal down and count to 30. Reconnect the battery, and the ECU is now reset.
