The fan will not turn on till your vehicle is at operating temperature. Check it again when the engine is hot.
tiburon 2.0 Intake air temperature (IAT) sensor lokation?
THE AUTOMATIC TRANS OIL TEMP SENSOR IS LOCATED ON THE A/T VALVE BODY BEHIND THE PAN.
it is on the tranny.
www.hyundaiusa.com. Pls see the answer to the question posted Sep 30, 2006 "Where can you get free technical information for Hyundai cars?" for details.
In the 2000 Hyundai Tiburon, the temperature sensor, also known as the coolant temperature sensor, is typically located near the thermostat housing on the engine. It is usually positioned on the engine block or cylinder head, where it can accurately measure the temperature of the coolant. To access it, you may need to remove some components, depending on the engine configuration. Always refer to the vehicle’s service manual for specific details and procedures.
crankshaft? what crankshaft? I think thats the engine connector you're pulling
Go to www.hmaservice.com and set up a account. "it's free" and then you will find access to wiring and mechanical service data.
where is the coolant temp sensor located on a 2006 hyundai sonata
On a 2003 Hyundai Tiburon with a 4-cylinder engine, the intake air temperature (IAT) sensor is typically located in the air intake duct, just before the throttle body. It can usually be found near the mass airflow sensor (MAF) or integrated within it. To access it, you may need to remove part of the air intake system. Always consult the vehicle's service manual for precise details and locations.
On a 2001 Hyundai Tiburon SE, the O2 sensor Bank 1 Sensor 1 is located on the exhaust manifold, upstream of the catalytic converter. It is positioned on the driver's side of the vehicle, typically near the engine block. This sensor monitors the oxygen levels in the exhaust gases before they enter the catalytic converter for optimal fuel mixture adjustments.
The transmission temperature sensor on a 2001 Hyundai Tiburon is typically located on the transmission itself, often near the oil pan or on the side of the transmission case. It may be necessary to lift the vehicle for better access. Always consult the vehicle's service manual for the exact location and any specific instructions for removal or installation.
To replace the speed sensor on a 2001 Hyundai Tiburon with a manual transmission, first, locate the sensor, which is typically found on the transmission housing. Disconnect the wiring harness and remove the retaining bolt securing the sensor. Pull the old sensor out and insert the new one, securing it with the bolt and reconnecting the wiring harness. Finally, check for any leaks and ensure proper operation before finishing up.