On a 2003 Hyundai Tiburon with a 4-cylinder engine, the intake air temperature (IAT) sensor is typically located in the air intake duct, just before the throttle body. It can usually be found near the mass airflow sensor (MAF) or integrated within it. To access it, you may need to remove part of the air intake system. Always consult the vehicle's service manual for precise details and locations.
tiburon 2.0 Intake air temperature (IAT) sensor lokation?
A person should know the location of the sensors in a vehicle. The IAT sensor is located on the air intake housing of this vehicle.Ê
it is on the tranny.
hyundai tiburon 2001 all vacum hoses OK new spark plugs i have spark engine will start but hard to start firing order OK but wont stay on what can it be is it intake sensor or not enough fuel pressure
Where Is The Cam Sensor On A 2003 Hyundai Sonata 4 Cylinder
The throttle position sensor (TPS) on a 2005 Hyundai Tiburon is located on the throttle body, which is situated on the intake manifold. To access it, you may need to remove the air intake hose and possibly other components obstructing your view. The TPS is typically mounted directly on the throttle body, connected to the throttle plate shaft. Always consult the vehicle's service manual for specific details and procedures.
IAT - Intake(or incomming) air temperature sensor. It will be located along the air intake tube. It is usually either on the airbox or right after. Before you get to the mass airflow sensor. It usually just is held in the tube by a grommet. Undo the connector and pull it out.
In the 2000 Hyundai Tiburon, the temperature sensor, also known as the coolant temperature sensor, is typically located near the thermostat housing on the engine. It is usually positioned on the engine block or cylinder head, where it can accurately measure the temperature of the coolant. To access it, you may need to remove some components, depending on the engine configuration. Always refer to the vehicle’s service manual for specific details and procedures.
its the cable attached to the stock intake.
Go to www.hmaservice.com and set up a account. "it's free" and then you will find access to wiring and mechanical service data.
The sensor should be located on the intake boot(air intake system) or on the intake manifold.
THE AUTOMATIC TRANS OIL TEMP SENSOR IS LOCATED ON THE A/T VALVE BODY BEHIND THE PAN.