Are you sure that it's third it's not shifting into, and not fourth? The transmission is designed to not permit shifts into fourth (overdrive) until the engine and transmission have warmed up a bit.
The third brake light on a 2007 Toyota Avalon is replaced by first removing the rear, retaining screws. The wiring harness can then be disconnect and the light bulb removed.
The 2007 Toyota Avalon windshield washer relay switch can be found in the fuse box. The windshield washer relay switch will be in the third column, second from the top.
More than likely your shift cables need to be lubricated.
A car with an automatic transmission shifts itself from 1st to 2nd to 3rd when you accelerate. You don't need to shift it...that's why they call it automatic.
To change the third brake light on a 1999 Toyota Avalon, first, open the trunk and locate the access panel on the rear deck where the light is situated. Remove the screws or clips holding the panel in place, then carefully lift it out. Disconnect the wiring harness from the old light, replace it with a new bulb or assembly, and reconnect the wiring. Finally, reattach the access panel and secure it with the screws or clips.
The Third Shift was created in 2004.
If you open the trunk and go under the 3rd stop light, you should be able to pull the lining of the trunk down so you can change it...
In automatic transmissions the second to third syncronizers always seem to go bad first, the syncronizers are worn, bad or gone. This is common in these transmissions. Also you might check your trans fluid level, sometimes a low level will cause the transmission not to shift correctly.
Avalon strollers are sold exclusively online. You can buy them at Avalon's online website. You can also buy them through third-party websites as well.
There are tiny bearings and gears that make the trans shift smoothly and keep it in the right gear and when they go bad your car can develop a rough shift slipage and even trans failure
To change the third brake light on a 2002 Toyota Avalon, first, open the trunk and locate the plastic cover or trim panel at the rear of the trunk near the brake light. Remove any screws or clips securing the panel and carefully detach it to access the brake light assembly. Twist the bulb socket counterclockwise to remove it, replace the old bulb with a new one, and reassemble the panel by reversing the steps. Finally, test the new brake light to ensure it's functioning properly.
To replace the third brake light on a 2007 Toyota Avalon, first, open the trunk and locate the plastic cover that conceals the brake light assembly. Remove the cover by unscrewing or unclipping it, then disconnect the electrical connector from the old light assembly. Next, remove the old brake light by unscrewing or pulling it out, and install the new light by reversing the process. Finally, reconnect the electrical connector and replace the plastic cover.