# Start with the key out of the ignition. Open the driver door (all other doors are closed). Driver door is unlocked (other doors don't matter). # Perform these steps within 5 seconds ## Insert the key into the ignition (don't turn it) Pull key out ## Insert the key into the ignition (don't turn it) Pull key out # Perform these steps within 40 seconds ## Close, then open the drivers door. ## Close, then open the drivers door. ## Insert the key into the ignition (don't turn it) and pull it out. # Perform these steps within 40 seconds ## Close, then open the drivers door. ## Close, then open the drivers door. ## Insert the key into the ignition and leave in the ignition. ## Close the drivers door
Turn the ignition to ON (as far as you can go without cranking the engine), then back to off . ## Remove the key from the ignition. # Within 3 seconds, the power door locks should lock then unlock automatically indicating successful entry into programming mode. Return to step 1 if the locks do not cycle at this point. # Perform these steps within 40 seconds ## Press the lock and unlock buttons on the transmitter simultaneously for 1.5 seconds ## Immediately after letting go of the lock and unlock buttons, press the lock button by itself and hold for 2 seconds. Within 3 seconds, the door locks should lock then unlock once indicating successful programming. If the door locks cycle twice, repeat steps 6a and 6b as the remote was not accepted. # Open drivers door
I have an '04 Highlander and have this capability without any special programming. To unlock the drivers door ONLY, press the remote ONCE. To unlock ALL the doors AND the rear hatch, press the remote TWICE within 3 seconds.
take it to the dealership
To program the garage door opener in a 2002 Toyota Highlander, first, ensure that your vehicle is parked outside of the garage. Hold down the two outer buttons on the HomeLink system until the indicator light begins to flash, indicating it’s cleared for programming. Next, press and hold the button on your garage door remote while simultaneously pressing the desired HomeLink button in your Highlander. Release both buttons when the indicator light changes from a slow blink to a solid light, confirming successful programming.
Google EHOW and they will give you exact directions on how to do it. It's kinda convoluted but does work.
yes,it is expensive 125.00 but if you loose the master key it will run 500.00 and 1000.00 to get a new computer plus 75.00 to reprogram.the master is the only key that opens the glove box.i know this first hand i bought a used Toyota 2003 highlander with no master and had to fight the dealer to eat up the cost and still had to pay for programming and a remote.
u do it the same way as the first one. ie follow the same steps, but hold the 2nd button to program it to that button
a
My Toyota Yaris does not have a remote. That might explain it.
It is easy to do with online instructions. Just google "2004 Jeep remote programming"
To program a keyless remote for a 2002 Toyota Solara, first, sit in the driver's seat and close all the doors. Insert the key into the ignition and turn it to the "On" position, then back to "Off" five times within 15 seconds. After the fifth turn, the locks should cycle, indicating that the vehicle is in programming mode. Finally, press the "Lock" button on the remote, and the locks should cycle again to confirm programming. Repeat for additional remotes if needed.
remote receiver
originalkeyless.com they have the remote and the programming for Mazda 929's