http://wiki.answers.com/Q/Toyota_rav_4_maint_required_light_2008"
read your owners manual
Where is the fuel pump inertia circuit breaker located on a 2008 Toyota Corolla
Hold down the "trip reset" button with the ignition off and keep it pressed while you turn the ignition on
To reset the "Maint Reqd" light on a 2008 Toyota Corolla, turn the ignition to the "ON" position without starting the engine. Press the gas pedal three times within five seconds. After doing this, the light should turn off, indicating that the maintenance reminder has been reset. If it doesn't reset, repeat the steps to ensure they are done correctly.
How to Reset Maintenance Warning Light on a 2008 Toyota 4Runner
The 2008 Toyota FJ-Cruiser runs on premium unleaded (required).
That info is in your owner's manual The dashboard light dimmer is the same stem used to toggle between and zero the trip meters (and, incidentally, reset the "Maint" light after an oil change). Just turn the stem left (lower) or right (higher) to adjust the lighting to your preference. Cheers
Prees odo meter button down and turn on ignition wait 10 seconds
There is no light on the steering wheel.
1. Turn the key to "on" so that electrical system is fired up (but engine is not running) 2. Set trip planner to "A" trip. 3. Turn key off (no electrical) 4. Hold down trip planner button, then turn key to "on" so that electrical system is fired up (but engine is not running). 5. "Maint Req" light will blink several times and then go off.
2008 1.6 petrol toyota avensis timing belt or chain ?
How do you reset maintenance reminder light on 2008 Toyota corolla? For what it is worth: To reset the Maintenance Required light on my 2007 Toyota Corolla: 1) Set your trip meter to the odometer setting (in other words, not Trip A or Trip B) 2) Hold down trip meter reset button and turn ignition to off. 3) While holding down the trip meter reset button now turn the ignition to on. 4) Keep holding down button until Maintenance Required light shuts off. Note: One some other Toyota models you hold down the Trip A meter rather than the odometer. Hope this works for you.