If you pull one of the front wheels the minimum thickness should be stamped or molded into the brake rotor near the hub area. I own a 2000 CR-V and the minimum thickness on mine shows as 18 millimeters.
there should be a Honda stamp on the inside center of the rotor
The minimum brake rotor thickness for a 2005 Honda Odyssey is typically 26.5 mm (1.04 inches) for the front rotors and 10 mm (0.39 inches) for the rear rotors. It's essential to measure the rotors periodically and replace them if they fall below these specifications to ensure safe braking performance. Always consult the vehicle's manual or a professional for the most accurate information.
Torque specs for brake caliper bolts 2005 mazda 6
You will need to remove the tire and wheel from your 2005 Dodge Durango. Remove the brake pad Springs and calipers. Tap the rotors with a hammer to loosen them. Slide the rotors off. Reverse the process to install the new rotors and brake pads.
The minimum thickness or a front brake rotor to be turned is one quarter of an inch. If the brake rotor is less than a quarter of eight inch. It must be discarded.
Go to Honda's web site.
Warped brake rotors.
WELL, I HAVE A 2005 TOYOTA SUV AND I JUST HAD MY FRONT ROTORS AND BRAKE PADS REPLACED AND IT COST ME 325.00. If you do it your self it is about 140.00
The new pads will last longer, work better, and be quieter if the rotors are resurfaced.
The factory Honda pads. (OEM)
You either have a bad brake caliper or the brake hose is bad.
what it the torque spec for head bolts on a 650 honda rincon 2005