The 1992 Mitsubishi 3000GT typically features a 5-speed manual transmission with gear ratios approximately as follows: 1st gear is about 3.09:1, 2nd gear is around 1.89:1, 3rd gear is approximately 1.29:1, 4th gear is about 0.97:1, and 5th gear is roughly 0.75:1. For the automatic transmission variant, the gear ratios may differ slightly. These ratios contribute to the vehicle's performance characteristics, balancing acceleration and fuel efficiency.
Bad struts can cause vibrations while coasting in first gear on a 1993 Mitsubishi 3000 GT VR4. A bad tire can also cause this.
0 - 60mph is 5.7 sec (top gear test) Mitsubishi gto 3000 Top Gear tested a VR4... Which was 5.7.. 0-60 in a non-VR4 Mitsubishi 3000gt from 1991-93 is approx. 7.5-8 seconds.
Weld center diff and remove front ring gear. Remove front axles. has been done.
Yes I would ask Mitsubishi about that because I know someone who had the same problem and it cost them 200 pounds to fix
The 1992 Ford Festiva typically features a 5-speed manual transmission with gear ratios of approximately 3.36:1 for first gear, 1.89:1 for second, 1.24:1 for third, 0.87:1 for fourth, and 0.73:1 for fifth. The final drive ratio is generally around 3.89:1. These ratios contribute to the car's efficiency and performance. Always check the specific vehicle's manual or manufacturer specifications for precise information.
To fix the gear shifter in a Mitsubishi 3000GT, first, ensure the car is in neutral and the battery is disconnected for safety. Inspect the shifter assembly for any loose bolts or damaged components, such as bushings or cables, and replace them as necessary. If the issue persists, check the linkage for proper alignment and adjust as needed. Finally, reassemble everything, reconnect the battery, and test the shifter for proper functionality.
why is my 1996 Mitsubishi lancer evo stuck in gear
Reduction ratios: 1st gear 2.45:1 2nd gear 1.45:1 3rd gear 1:1 Overdrive 0.69:1 Reverse 2.22.1
The gear ratio is the number of teeth in the driven gear divided by the number of teeth in the drive gear.
Yes, they often are. Gear ratios and anatomical ratios are usually expressed in decimal numbers in relation to one.
I Have a 1991 3000gt Sl and the ECU Is located Behind the radio and can accessed by removing the side carpet panals for your gear shifter.
Depends on the engine at what it's cruised at, revolutions per mile of the tires, transmission gear ratios, and rear end gear ratios.