answersLogoWhite

0


Best Answer

What are the torque specs for a 2001 Honda Passport head gasket

User Avatar

Wiki User

10y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What are the intake manifold torque specs for Honda Passport 3.2l?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

At what torque must the Intake Manifold Bolts be tightened to on a Honda passport 97?

18 ft lbs


Where is the thermostat on a 99 Honda Passport?

Not an easy job.You need to remove the intake manifold plenum to do it.


Where is the map sensor on a 1989 through 2002 Honda Passport?

On 89 thru 97 3.2L Passports, Rodeos, and Amigos the MAP or Manifold absolute pressure sensor is located on the right side of the intake manifold. On 98 and later it is on the right rear upper corner of the intake manifold, and on the 2.2L it is on the upper side of the intake manifold between the throttle body and the cylinder head


Where is starter located on 2004 Honda accord?

under the intake manifold. you have to remove all intake hose and intake manifold itself to get to the starter.


What is the torque spec for the exhaust manifold on a 95 Honda Odyssey?

The 1995 Honda Odyssey exhaust manifold bolt torque specification is 45 pounds. The exhaust manifold bolts should be torqued in 15 pound intervals.


Where is the PCV located in a 1995 Honda Passport EX 6cyl?

driver's side/front on the valve cover. very visible and easy. Then there is a vac line heading to the intake manifold.


Where is the intake manifold tuning valve control circuit on a honda cr-v?

on the side of the intake manifold. opposite side of the throttle body


Where is the location of the Map sensor on a Honda F20A engine?

On intake manifold


Where is the starter in a 2005 Honda Accord Coupe?

behind the intake manifold


Honda civic HX o2 sensor?

Close to the Intake Manifold


Where is the starter located on a 2005 Honda Element?

It is located next to the gas tank. No it is not. It's under the intake manifold. You must remove the intake manifold to get to it.


How hard is it to fix a blown head gasket in a 95 honda passport?

It is a major repair that requires removing intake and exhaust manifold. Then removal of the head. Requires skill, knowledge, and the proper tools.