On a 1992 Isuzu pickup with a 2.3L carbureted engine, the timing marks are typically located on the crankshaft pulley and the timing cover. The crankshaft pulley will have a notch or mark that aligns with a corresponding mark on the timing cover. To set the ignition timing, you usually align these marks when the engine is at the specified top dead center (TDC) for the number one cylinder. Consult the vehicle’s service manual for the exact TDC position and timing specifications.
Take it to mechani
use a lot of extensions and a rachet, with bendy peices its under everything on the left
Carb.? At the fuel inlet at the carb.
below the right side of carb.
Yep.
carb or timing
AnswerReplace your Idle Air Control valve, also known as the IAC motor. Cheap part that causes this type of problem. AnswerYou should also check the ignition timing. If it is not set correctly, the engine cannot run well. A matter of two degrees on the timing cam mean the difference between running badly, or properly. replace the fuel filter.
1985- 1995 will work, 22r and 22re are the same head these years. 84 will NOT WORK so make sure its a 85+
timing or carb
You don't have a carb on that vehicle, it is throttle body fuel injected.
Check your timing and your vacuum advance.
um..........i have NO idea