Perhaps this color code chart can help:--- 12V battery wire = pink or pink w/white stripe--- 12V ignition wire = red w/white stripe--- Illumination = orange--- Power antenna = white--- Dimmer = none--- SPEAKERS--- Front left(+) = dark green--- Front left(-) = brown w/red stripe--- Front right(+) = purple--- Front right(-) = blue w/red stripe--- Rear right(+) = blue w/orange stripe--- Rear right(-) = blue w/white stripe--- Rear left(+) = brown w/blue stripe--- Rear left(-) = brown w/yellow stripe---
A 1997 Chevrolet Silverado radio wiring harness color codes chart can be obtained from most Chevrolet dealerships. The wiring harness color code chart can also be obtained from most auto-parts stores.
you pull out the radio and dash cluster and you will have full access to the ignition just turn it over and un clip the wires
Battery RED + (+) IGNITION SWITCH HARNESS Accessory01 ORN + (+) IGNITION SWITCH HARNESS Ground BLK - (-) RADIO HARNESS Illumination GRY (+) RADIO HARNESS FrontLeftSpeakerPos TAN FrontLeftSpeakerNeg GRY FrontRightSpeakerPos LT.GRN FrontRightSpeakerNeg DARK GREEN RearLeftSpeakerPos BRN RearLeftSpeakerNeg YEL RearRightSpeakerPos DK.BLU RearRightSpeakerNeg LT.BLU
You can find a radio wiring harness for your 1997 Ford at most auto-parts stores. Many electronic stores will also have the radio wiring harness.
Try these out ...... Radio 12v pink + radio harness Radio Ground black - radio harness Radio Ignition pink + radio harness Radio Illumination blue/black + radio harness Factory Amp Turn-on N/A Power Antenna green/black + radio harness LF Speaker +/- blue/red - yellow/black +,- radio harness RF Speaker +/- black - yellow +,- radio harness LR Speaker +/- brown - white +,- radio harness RR Speaker +/- green/orange - blue/orange +,- radio harness
you need the proper wiring harness to change the stereo in a cobalt or the security features will kick in once you have the proper harness you just have to match wires
The wiring harness for the radio in a 1991 GMC Pickup is going to be behind the radio. The wiring harness is plugged into the back of the radio. The fuse for the radio is in the fuse box located on the driver's side below the dashboard.
Answering "http://wiki.answers.com/Q/The_wiring_harness_plug_was_cut_off_your_97_E350_ford_radio_and_you_want_to_install_a_radio_but_you_dont_know_which_is_the_color_for_radio"
brown/green + radio harness Radio Ground black - radio harness Radio Ignition white/red + radio harness Radio Illumination blue (dimmer) + radio harness LF Speaker +/- white/black - yellow/black +,- radio harness or amp RF Speaker +/- white/red - yellow/red +,- radio harness or amp LR Speaker +/- white/blue - yellow +,- radio harness or amp RR Speaker +/- white - yellow +,- radio harness or amp Lee Curle Owner- Custom Car Audio, Newton,KS
buy a aftermarket wiring harness if your factory harness is cut good luck use a test light or meter to find your constant power and ignition then trace speaker wires the positives on the rear speakers is dark collered wires little hint to limit your problems
Usually when you get the radio the place you bought it will have a wiring harness that will fit the car. If not then go to a radio installation shop and ask for one. This will then plug right into the factory car harness and then you connect the radio to this harness. That's it. Good luck.
Before you tear the wiring harness up in the car, they make wiring harness adapters that will plug right in to the vehicle and then you just hook it up to the new radio. Any radio installation shop should have these. This is a lot easier when installing a new radio or sound unit. Hope this helps. Good luck.