answersLogoWhite

0

The stalling issue in your 1991 Mazda Miata when using the high beams or turn signals could be caused by an electrical system problem, such as a weak battery or faulty alternator not supplying enough power. Additionally, a short circuit or poor ground connection in the lighting circuit may be drawing too much current, leading to a stall. It's also possible that there could be an issue with the ignition system that is exacerbated by the increased load from the lights. A thorough inspection of the electrical system, including the battery, alternator, and wiring, is recommended.

User Avatar

AnswerBot

1w ago

What else can I help you with?

Related Questions

Problems with 2000 Mazda 626 on lights signal?

You should clarify your problem or question. Is it the front or rear signal light? Is the tail light coming on with the signal light? Are none of the lights coming on at all?


How do you replace the front turn signal bulb located on a 1994 Mazda 626?

Most of the cars now have composite lights and the lights have to be revomed to replace the bulbs.


How do you repair signal lights on Mazda B2200?

To repair signal lights on a Mazda B2200, start by inspecting the bulbs for any signs of burnout and replace them if necessary. Check the fuses related to the turn signal circuit, replacing any that are blown. If the bulbs and fuses are fine, examine the wiring and connectors for corrosion or damage, and repair or replace them as needed. Finally, test the turn signals to ensure they are functioning correctly.


When I was driving my Mazda 6 all the dash board lights came on and my car just stopped turned off?

sounds like an alternator problem


The indicators work but the hazard lights do not on a 1983 Mazda 323 how do you fix this Where do you look?

Your car has two flasher relays. One for the turn signal lights and one for the hazard lights. Replace the one for the hazard lights. Any auto parts store can tell you the location and sell you a new one.


How do you recharge the ac on a 1995 Mazda MPV if the compressor won't engage how do you make it engage?

?


What are the warning lights for a Mazda rx8?

There are numerous warning lights for a Mazda RX8. Some of the warning lights are for engine oil, charging system, ABS, and check engine.


No brake light on 1998 Mazda pickup?

If there is no brake lights on a 1998 Mazda pickup, check the fuse. If the fuse has blown, the lights will not work.


1992 Mazda Miata-tail lights work for reverse brake and turn signal only Dash light does not come on either. How do you get them to stay on?

You will need to check the ground wires. A loose ground wire can cause the lights to work sometimes and sometimes not to work.


Mazda 626 Turn Signal Relay?

The Mazda 626 turn signal relay switch can be found below the dashboard on the drivers side of the passenger compartment. The turn signal relay switch should be labeled as such.


Where is the fuse for the turn signal in a Mazda?

In the fuse box.


How do you replace the dash light fuse on 1990 Mazda MPV?

The fuse panel is under the dash by the driver. If your parking lights are also out, your headlight/parking light/turn signal switch is bad.