The cost to replace struts on a 2004 Lexus RX330 typically ranges from $800 to $1,500, depending on the parts used and the labor rates in your area. Aftermarket struts may be less expensive, while OEM parts will generally cost more. Labor costs can vary significantly based on the shop's hourly rate and the complexity of the replacement. It's advisable to get a few quotes from different mechanics for an accurate estimate.
19.2 gal according to http://www.planetlexus.com/lexus-rx330/lexus-rx330.html
Once you get the correct 2004-2006 Lexus RX330 special rear wiper blade it is very easy to replace. See sources and related links below.
Once you get the correct 2004-2006 Lexus RX330 special rear wiper blade it is very easy to replace. See sources and related links below.
The 2004 Lexus RX330 is equipped with a 3.3-liter V6 engine, which has six cylinders. This engine configuration provides a good balance of power and efficiency for the vehicle.
87 or higher, enjoy!
Front door I believe are 6x9's
The thermostat on a 2004 Lexus RX330 is located in the engine compartment, specifically at the engine's front, near the upper radiator hose. To access it, you typically need to remove the engine cover and possibly the intake manifold, depending on your level of access. It's advisable to consult a repair manual or a professional for detailed instructions if you're planning to replace it yourself.
power tail gate on 2004 Lexus RX 330 will not open when hot from sitting in the sun.
Where is fuse panel for RX330 (2004) located in cabin?
3.3L V6 use timing belt.
In the 2004 Lexus RX330, the ashtray is located in the center console, just in front of the gear shift. It can be accessed by lifting the lid of the console compartment. Additionally, there is a second, smaller ashtray located in the rear of the center console for rear passengers.
To replace the brake light module on a 2004 Lexus RX330, first, ensure the vehicle is turned off and the keys are removed. Remove the tail light assembly by unscrewing the screws and gently pulling it away from the vehicle. Disconnect the electrical connector from the brake light module, then replace it with the new module by connecting the electrical connector and securing the tail light assembly back in place. Finally, test the brake lights to ensure proper functionality.